advanced features
.
Check Result of Test
47
If the satellite receiver’s channel number has been changed to the same channel as you set ...
Press the Aand Bbuttons to move the
highlight bar to CHANGED TO ..., then press | 3 | OK / |
|
|
(or E) to finish the Sat Control Set mode.
If the satellite receiver’s channel number
has not been changed correctly ...
Press the Aand Bbuttons to move the
highlight bar to NOT CHANGED, then press | 3 | OK / |
|
|
(or E). Then perform the procedure again from entering the satellite receiver’s brand code.
SAT CONTROL SET
SAT PROG : 111
FCHANGED TO 111
FNOT CHANGED
[1] a k [MENU]: EXIT
Notes
•The Satellite Controller may not work with all types of satellite receiver.
•For some satellite receivers, you need to set its channel input mode to
•If your satellite receiver has more than two channel modes, be sure to set to All Channel Mode. For details, refer to the instruction manual of the satellite receiver.
•When selecting the satellite receiver’s preset position for testing, signals from the Remote Control may interfere with signals transmitted from the Satellite Controller. In this case, move the Remote Control as close to the recorder’s infrared beam receiving window as possible.
