SUBSIDIARYSETTINGSEN49

Video Channel Set

Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.

IMPORTANT

Perform the following steps only if —

Video Channel Set has not been done correctly by the Auto Set Up function (pg. 6).

interference appears in the TV picture after you have moved to a different area or a new station has started broadcasting in your area.

you change the connection between your recorder and TV from RF connection to AV or S-VIDEO connection, or vice versa.

If you have connected the video recorder to your TV via both the provided RF cable and a 21-pin SCART cable (AV connection), or via the provided RF cable, an S-Video cable and an audio cable (S-VIDEO connection), since you do not need the video channel you have to set the video channel to off.

If you have connected the video recorder to your TV via the provided RF cable only (RF connection), you have to set the correct video channel.

Before performing the following steps, make sure the recorder's power is off and there is no cassette inserted in the recorder.

1

2

ACCESS VIDEO CHANNEL SET MODE

Hold down STOP (5/8) on the recorder until the display panel shows the following.

SET VIDEO CHANNEL

With AV Connection or S-VIDEO Connection

Press TV PROG – until the display panel shows "OUT– –".

Now the video channel is set to off.

With RF Connection

Press TV PROG + or to set the video recorder to a vacant channel between 22 and 69 which is not occupied by any local station in your area.

(Ex.) If channel 50 is available in your area

Then set your TV to UHF channel 50.

If the two vertical white bars appear clearly on the screen as shown to the right, go to step 3.

If the two vertical white bars do not appear clearly, re-set the video recorder to another vacant channel and try again.

NOTES:

If you set the video recorder to a channel which is occupied by a local station or has neighbouring channels that are occupied by local stations, the picture reception quality will be affected and some interference noise will appear on the TV screen. Be sure to select a vacant channel which has no broadcast on neighbouring channels.

If you cannot obtain the two vertical white bars clearly with any channel between 22 and 69, consult your JVC dealer.

EXIT VIDEO CHANNEL SET MODE

3 Press OK on the remote control.

With AV Connection or S-VIDEO Connection:

To view picture signals from the video recorder, set your TV to its AV mode.

With RF Connection:

The channel on which the screen in step 2 appears clearly is your video channel.

To view picture signals from the video recorder, set your TV to the Video Channel.

Page 49
Image 49
JVC HR-S8500E/EH Video Channel Set, Access Video Channel SET Mode, SET Video Channel, Exit Video Channel SET Mode