JVC HR-S9600EK setup guide or If -- appears on the display panel, refer, Program number set

9

PRESET DOWNLOAD

SET THE TUNER CHANNELS BY DOWNLOADING FROM YOUR TV, CLOCK AND GUIDE PROGRAM NUMBERS

When you connect the recorder and your TV via fully-wired 21-pin SCART cable (☞ pg. 6), you can set the recorder's tuner channels by downloading preset data from your TV instead of using the Auto Set Up function (☞ pg. 8). After downloading is completed, the recorder sets the clock and VIDEO Plus+ assigned Guide Program numbers automatically.

For details, refer to the instruction manual for your TV.

ATTENTION

You can use this function only with a TV offering T-V Link, etc.*

*Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully-wired 21-pin SCART cable. The degree of compatibility and available functions may differ by system.

Before performing the following procedure, make sure that:

■the TV aerial cable is connected to the recorder and a 21-pin SCART cable is connected between your TV and the recorder.

■the mains power cord is plugged into the mains outlet.

■batteries have been installed in the remote control.

				1	Press	. If "Auto" appears on the display
					panel, Press %Þ to select "CH – –" and
					press OK or #. Preset position on the
					display panel increases from "CH1";
					do NOT press any button on the recorder				T-V LINK
					or remote control until the display panel
					shows either the display as illustrated on				PLEASE WAIT
					page 10 or "– – :– –".
					● If "– –:– –" appears on the display panel, refer
					to page 10.
					● If you are using the on-screen display, the T-V
					LINK screen will appear. Then the GUIDE				[MENU] : EXIT
					PROG SET screen will appear during Guide
					Program number set.
1		– –:– –			● If you press any button on the recorder or
2					remote control while downloading is in				GUIDE PROG SET
					progress, this process will be interrupted and
1	2	3
4	5	6			you will need to start again. See NOTES below.				PLEASE WAIT
7	8	9	3
	0		4
			4
1			3						[MENU] : EXIT
2
				2	Press	to turn off the recorder. Press
					and hold down STOP on the recorder
					until the display panel shows the display
		￿			as illustrated on the right. Press TV PROG –
					until the display panel shows "_OUT– –"
					to set the Video Channel to off.
				3	Press OK to exit Video Channel Set mode.
					To view picture signals from the video recorder, set your TV to its AV mode.
					— Refer to the instructions supplied with your TV set for how to do this.
NOTES:
● In areas where no TV station transmits the PDC signal, the recorder cannot perform either auto clock set or auto Guide Program
number set.
● If there is a power cut, or if you press				or MENU while downloading or set up is in progress, it will be interrupted; be sure to
turn off the recorder power once and try again from the beginning.
● Auto clock may not function properly depending on reception conditions.
● When you perform T-V LINK function, be sure to use fully-wired 21-pin SCART cable.
● On this recorder, the characters available for station names (ID) are A–Z, 0–9, –,							, + and	(space). The names of some
downloaded stations may differ from those on your TV (☞ pg. 58).							*