JVC HR-VP680U manual 42 EN, Timer Recording

42 EN				TROUBLESHOOTING (cont.)
	TIMER RECORDING
		SYMPTOM	POSSIBLE CAUSE		CORRECTIVE ACTION
	1.	Timer recording will not work.	● The clock and/or the timer have		Set the clock and/or timer correctly.
			been set incorrectly.
			● The timer is not engaged.		Press TIMER and check to make sure
					that ä appears on the front display
					panel.
			● The VCR has not been set up properly.		Re-perform the set-up procedures.
					Make sure you have compensated for
					guide channel and VCR or cable box
					channel number mismatches
					(☞ pg. 26).
	2.	Timer programing will not work.	● Timer recording is in progress.		Timer programing cannot be performed
					when timer recording is in progress.
					Wait until it finishes.
	3.	ä and ] on the front display	● The timer is engaged but there is no		Load a cassette with the record safety
		panel will not stop blinking.	cassette loaded.		tab intact, or with the hole covered
					with adhesive tape.
	4.	The cassette is automatically	● The loaded cassette has had its		Remove the cassette and cover its
		ejected, and ä and ] on the	record safety tab removed.		hole with adhesive tape, or replace it
		front display panel will not stop			with a cassette on which the safety
		blinking.			tab is intact.
	5.	ä blinks for 10 seconds and the	● TIMER has been pressed when there		Check the programed data and set
		timer mode is disengaged.	are no programs in memory, or the		again if necessary, then press TIMER
			timer recording program has not		again.
			been set correctly.
	6.	The cassette is automatically	● The tape reaches its end during		The program may not have been
		ejected, the power shuts off and ä	timer recording.		recorded in its entirety. Next time be
		and ] will not stop blinking.			sure you have enough time on the
					tape to record the entire broadcast.
	7.	You moved, and now VCR Plus+	● The receivable stations in the new		Re-perform the VCR Plus+ setup
		does not work properly.	area are received on different		procedure (☞ pg. 26).
			channels than those in the previous
			area.
	8.	“PROGRAM FULL” is displayed on	● All 8 programs of the VCR’s timer		Wait until a space in memory clears,
		the screen.	memory are used.		or cancel unnecessary program
					information (☞ pg. 30).
	OTHER PROBLEMS
		SYMPTOM	POSSIBLE CAUSE		CORRECTIVE ACTION
	1.	When scanning channels, some of	● Those channels have been preset to		If you need the skipped channels,
		them are skipped over.	be skipped.		restore them (☞ pg. 14).
	2.	The channel cannot be changed.	● Recording is in progress.		Press PAUSE ( 8 ) to pause the
					recording, change channels, then
					press PLAY ( 3 ) to resume recording.
	3. The Remote will not operate your		● The brand codes are set incorrectly.		Reset the correct brand codes (☞ pg.
		TV or cable box or DBS receiver.			37, 38 or 39).
	4.	Even though Auto or Semiauto	● The clock setting data received from		Select a different host channel during
		Clock Set has been performed, the	the host channel is incorrect.		Semiauto Clock Set (☞ pg. 11), or
		clock is incorrect.			perform Manual Clock Set (☞ pg. 12).