Remote control

Inserting Batteries

 

 

1 Open the battery compart-

2 Install two “AA” batteries (supplied),

3 Replace the compartment

ment cover in the direction of

paying attention to the polarity

cover.

the arrow.

diagram in the battery compartment.

 

Battery precautions

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

Remote control basics

•Press POWER to turn the DVD/VCR on or off.

•Make sure TV/VCR/DVD switch is set to VCR/DVD.

•Tap VCR CH + or VCR CH –to move through the channels one channel at a time.

•The VCR CH +/–and SET +/–are also used to navigate on-screen menu system.

•You can directly access specific channels using Number keys pad.

•Each press of VCR or DVD, switches the screen between the VCR screen (VCR mode) and the DVD screen (DVD mode).

Operation

 

• Aim the remote control at the remote sensor and press control buttons

 

to operate.

 

• Operate the remote control within 30° angle on either side of the remote

Approx. 5 meters

sensor, up to a distance of Approx. 5 meters.

 

9