Connecting an Antenna or Cable TV

AAntenna:

Disconnect the antenna from the rear of the TV and identify the antenna cable. If it is a round 75 ohm coaxial cable connect it directly to the jack marked ANT.IN on your DVD+VCR. If your antenna cable is flat connect it to a 300-ohm to 75-ohm antenna adaptor (not supplied) and slip the adaptor over the ANT.IN jack. Don’t attempt to screw it into to the DVD+VCR.

BCable TV:

If your cable connection has no converter or descrambler, unscrew the cable from your TV and attach it to the ANT.IN jack on the DVD+VCR. If a converter is required connect a coaxial cable from the wall jack to the IN connector on the converter, and

a coaxial cable from the OUT connector on the con- verter to the ANT.IN on your DVD+VCR. This cable hookup permits both TV and DVD+VCR operation.

A

Antenna

Antenna

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OR OR

B

Rear of DVD+VCR

 

To view or record a CATV channel

1.Tune the TV to the DVD+VCR output channel (CH 3 or 4).

2.Set the DVD+VCR channel selector to the cable output channel. (Example: CH3)

3.Select a channel using the cable converter.

Notes:

With this connection, you cannot record one pro- gram while viewing another.

If you are using a cable box to tune channels, it is not necessary to do Auto Channel Set.

Basic TV Connections

Make one of the following connections, depending on the capabilities of your TV.

RF coaxial connection

Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on the TV using the supplied 75-ohm Coaxial Cable (R).

How to set the DVD+VCR’s RF output channel

1.When the DVD+VCR is turned off (standby mode), press and hold CH (- / +) on the front panel simultaneously for more than five seconds. “RF03” or “RF04” appears in the display window.

2.Press CH (- / +) to change the RF output channel (RF03 or RF04). Tune the TV to this channel.

3.Turn off the DVD+VCR.

Audio/Video connection

1.Connect the DVD/VCR VIDEO OUT jack on the DVD+VCR to the video in jack on the TV using an optional video cable (V).

2.Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on the TV (A1) using an optional audio cable.

Notes:

If you use this connection, set the TV’s source selector to VIDEO.

For DVD/VCR VIDEO OUT jack connection, resolution must be set to 480i or 480p, however DVD/VCR VIDEO OUT is always at 480i standard resolution.

10

Page 10
Image 10
JVC HR-XVC38BU, HR-XVC39SU manual Connecting an Antenna or Cable TV, Basic TV Connections