TUNING
This DVD+VCR is equipped with a frequency synthe-
sized tuner capable of receiving up to 181 channels.
These include VHF channels 2-13, UHF channels
14-69 and CATV channels 1-125.

Auto Channel Programming

Choose the SOURCE SELECT option, then use
b / B to select TUNER.
Use b / B to switch among TUNER, LINE1, and
LINE2.
Choose the AUTO CHANNEL SET option, then
use b / B to find channels.
The tuner will automatically cycle through all
available channels (TV/CATV) in the area and
place them in the tuner’s memory.
After the AUTO CHANNEL SET is complete,
the TUNING menu will hide and return to the
TV screen automatically.
Make sure the TUNING BAND is set appropriately
(TV or CATV).
TV : If you are using a standard antenna to
receive channels.
CATV : If you are using basic cable to receive
channels.

To Add or Erase Channels

This feature allows you to add or erase channels from
memory manually.
Choose the CH. ADD/DEL option, then use b / B
to select a channel to add or erase.
Use ENTER/OK to add or erase the channel.
Repeat steps 1 and 2 to add or erase other
channels.
Press SETUP MENU to return to the TV screen.
1.
2.
•
•
3.
•
•
1.
2.
3.
SETUP
FUNCTION OSD
The on-screen display can be turned on or off.
AUDIO MODE
The DVD+VCR has two separate audio playback sys-
tems, the high quality VHS Hi-Fi system and standard
NORMAL mono system. The same audio is generally
recorded on both systems. The VHS Hi-Fi system
plays on separate (left and right) channels, and the
NORMAL system plays monaural sound. The normal
track is always played so the cassette can be played
on a DVD+VCR that does not have VHS Hi-Fi.
BROADCAST TYPE (STEREO/SAP/MONO)
Multichannel Television Sound (MTS) carries stereo
and/or Second Audio Program (SAP) bilingual sig-
nals. Set this display to the desired position when
both MTS stereo and SAP signals are received.
When only one of the MTS signal is received, the
DVD+VCR automatically selects the corresponding
receiving mode (Stereo or SAP) regardless of the
selected position. For normal operation, the display
should be in the STEREO position. The DVD+VCR
will then record a STEREO program when available,
and record a mono program IF the program is NOT
IN STEREO. For weak STEREO and/or SAP broad-
casts, changing the display to mono may give clearer
sound.
AUDIO OUTPUT (STEREO/LEFT/RIGHT)
Used during playback [when AUDIO MODE (HI-FI/
NORMAL) is in HI-FI position] for selecting the audio
output signals from the AUDIO OUT terminals (L ch
and R ch), and RF.OUT. This display setting should
normally be left in the stereo position, so that when a
stereo tape is played, the stereo sound will be heard
through the left and right channels. If a mono tape is
played and the audio output is set to stereo, the same
mono sound will be heard from both left and right
channels.
15
Preparation