ELECTRICAL CONNECTIONS
ATypical Connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit. The leads of the power cord and those of the connector from the car body may be different in color.
1Connect the colored leads of the power cord in the order specified in the illustration below.
2Connect the antenna cord.
3Finally connect the wiring harness to the unit.
To CD changer or another external component (see diagram 
)
Rear ground terminal
Antenna terminal |
|
| Line out (see diagram |
| ) |
|
| ||||
| |||||
|
|
|
|
|
|
*2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
15 A fuse
Black
Yellow *2
Red
Blue
Blue with white stripe
Orange with white stripe
*1 Not supplied for this unit.
Ignition switch
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery (bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
Fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
To car light control switch
White with black stripe | White | Gray with black stripe | Gray | Green with black stripe | Green | Purple with black stripe | Purple |
| Left speaker (front) | Right speaker (front) | Left speaker (rear) | Right speaker (rear) | |||
BConnecting the external amplifier
You can connect amplifiers to upgrade your |
|
|
|
car stereo system. | Rear speakers | ||
• Connect the remote lead (blue with white |
|
|
|
stripe) to the remote lead of the other |
|
|
|
|
|
| |
equipment so that it can be controlled |
|
|
|
| JVC Amplifier | ||
through this unit. |
| ||
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Remote lead |
To the remote lead of other
equipment or auto antenna if any
Remote lead (Blue with white stripe)
*3 Firmly attach the ground wire to the metallic body
or to the chassis of the
with paint (if coated with paint, remove the paint
before attaching the wire). Failure to do so may cause
damage to the unit.
Front speakers
*4 Signal cord (not supplied for this unit)
CConnecting the external components
• Set “CHANGER” for the external input setting (see page 13 of the INSTRUCTIONS.)
CD changer, Apple iPod®, or JVC D. player
You can connect these components as illustrated below. The iPod*5 or D. player can be connected using an interface adapter (not
or
Apple iPod (separately purchased)
JVC D. player (separately purchased)
CAUTION:
•Before connecting the CD changer, make sure that the unit is turned off.
*5 iPod is a trademark of Apple Computer, Inc.,
registered in the U.S. and other countries.
JVC CD changer
CD changer jack
*6 Connecting cord supplied for your CD changer
• Set “EXT IN” for the external input setting (see page 13 of the INSTRUCTIONS.)
External Component
CD changer jack 
External component
External component
*7 Line Input Adapter
3.5 mm stereo mini plug
*8 AUX Input Adapter
2