JVC KD-SX9350 Adjusting the sound, English, Select the item you want to adjust, Loud, bass, To do

ENGLISH

Adjusting the sound

You can adjust the sound characteristics to your preference.

1 Select the item you want to adjust.

Each time you press the button, the adjustable items

change as follows:

For KD-SX9350:

BAS	TRE	FAD	BAL
(bass)	(treble)	(fader)	(balance)
VOL	WOOFER		LOUD
(volume)	(subwoofer)		(loudness)

For KD-SX990:

	BAS				TRE			FAD
	(bass)				(treble)			(fader)
	VOL				LOUD			BAL
	(volume)			(loudness)			(balance)
Indication			To do:					Range
BAS*1		Adjust the bass.				–06 (min.)
						+06 (max.)
TRE*1		Adjust the treble.				–06 (min.)
						+06 (max.)
FAD*2		Adjust the front				R06 (Rear only)
		and rear speaker
		balance.				F06 (Front only)
BAL		Adjust the left				L06 (Left only)
		and right speaker
		balance.				R06 (Right only)
LOUD*1		Boost low and
		high frequencies				LOUD ON
		to produce a well-
		balanced sound
						LOUD OFF
		at low volume
		level.
WOOFER*3		Adjust the				0 (min.)
(only for		subwoofer
KD-SX9350)		output level.				8 (max.)
VOL*4		Adjust the volume.				00		(min.)
						50		(max.)

*1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including “USER.”

*2 If you are using a two-speaker system, set the fader level to “00.”

*3 Only for KD-SX9350:

This takes effect only when a subwoofer is connected.

*4 Normally the control dial work as the volume control. So you do not have to select “VOL” to adjust the volume level.

2 Adjust the setting.

To increase the level or turn on the loudness

To decrease the level or

turn off the loudness

Equalization pattern changes as you adjust the bass or treble.

Ex. 1: When you adjust “TRE” (treble)

Ex. 2: When you turn on the loudness

3 Repeat steps 1 and 2 to adjust the other items.

To reset each sound mode to the factory

settings, repeat the same procedure and

reassign the preset values listed in the table on page 23.

24