ENGLISH

Changing the display mode while listening to an FM station

You can change the initial indication on the display to station frequency, station name (PS NAME), station frequency (FREQ) or clock time while listening to an FM RDS station.

• See also “Changing the general settings” on page 26.

1.Press and hold SEL (select) for more than 2 seconds to call up the general settings mode.

2.Select “DISPMODE” with ¢or 4.

3.Use the control dial to select the desired indication from the following: PS NAME (station name), FREQ (station frequency), and CLOCK (clock time).

Note:

By pressing DISP, you can also change the display while listening to an FM RDS station. Each time you press the button, the following information appears on the display:

PS NAME (Station name) FREQ (Station frequency)

CLOCK (Clock time) PTY (Programme type)

★The display returns to the initially preset mode after a short while.

Setting the TA volume level

You can preset the volume level for TA Standby Reception. When a traffic programme is received, the volume level automatically changes to the preset level.

• See also “Changing the general settings” on page 26.

1.Press and hold SEL (select) for more than 2 seconds to call up the general setting mode.

2.Press ¢or 4 to select “TA VOL (volume).”

3.Set to the desired volume level with the control dial.

Automatic clock adjustment

When shipped from the factory, the clock built in this unit is set to be readjusted automatically using the CT (Clock Time) data in the RDS signal.

If you do not want to use automatic clock adjustment, follow the procedure below.

• See also “Changing the general settings” on page 26.

1.Press and hold SEL (select) for more than 2 seconds to call up the general setting mode.

2.Press ¢or 4 to select “AUTO ADJ (adjust).”

3.Select “ADJ OFF” by turning the control dial counterclockwise. Now automatic clock adjustment is canceled.

To reactivate clock adjustment, repeat the same procedure and select “ADJ ON” in step 3 by turning the control dial clockwise.

Note:

It takes about 2 minutes to adjust the time using the CT data. So, you must tune to the station for more than 2 minutes continuously; otherwise, the clock time will not be adjusted.

16