JVC LET0227-003A Using the remote control unit, To install batteries, Remote sensor, Preparations

Models: LET0227-003A

1 47
Download 47 pages 17.98 Kb
Page 10
Image 10
Using the remote control unit

Preparations

Using the remote control unit

To install batteries

Open the compartment cover, and place the two supplied R6P (SUM-3)/AA(15F) batteries in the remote control unit according to the polarity markings (“+” and “– ”) inside the compartment. Then replace the cover.

Preparations

The batteries will last about six months with normal use. If the functions of the remote control unit become erratic, replace the batteries.

Precautions of the safe use of batteries

Observe the following precautions for the safe use of batteries. If they are used improperly their lives will be shortened, they may burst or their contents may leak.

Remove the batteries from the remote control unit if it is not going to be used for a long period of time.

Remove dead batteries and dispose of them properly.

Never leave dead batteries lying around, take them apart, mix them with other refuse, or throw them into an incinerator.

Never touch liquid that has leaked out of a battery.

Do not mix new and old batteries, or batteries of different types, when replacing them.

Remote sensor

Point the top of the remote control unit toward the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.

The illumination lamp flashes in a few seconds when the unit receives the remote signal from the remote control unit.

Remote sensor

Illumination lamp

8

Page 10
Image 10
JVC LET0227-003A manual Using the remote control unit, To install batteries, Remote sensor, Preparations