SAT CONTROL SET

17

Satellite Receiver Control Setting

Satellite receiver

Your recorder

Satellite Controller

 

(suggested locations)

Transmitter

Satellite Controller

 

(provided)

Satellite receiver

21-pin SCART cable

(provided)

SAT CONTROL

Back of recorder

AV2 (L-2) IN/DECODER

The following procedure is required if you receive satellite channels through a satellite receiver. Approximately 20 seconds before the VIDEO Plus+ timer programming ( pg. 36) or Express timer programming ( pg. 38) starts, the recorder sets its input mode to “L-2” and automatically switches the satellite receiver’s channels using the provided Satellite Controller.

Installing Satellite Controller

A Situate the Satellite Controller.

Place the Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.

B Attach the Satellite Controller.

Fix securely using the adhesive strip attached on the back of the Satellite Controller.

C Make connections.

Be sure to connect the recorder’s AV2 (L-2) IN/DECODER connector to the satellite receiver’s 21-pin SCART connector.

NOTE:

When connecting your satellite receiver, refer to its instruction manual.

D Connect the Satellite Controller to recorder.

Connect the Satellite Controller to the SAT CONTROL connector on the rear panel.

Page 17
Image 17
JVC LPT0679-001A Installing Satellite Controller, Situate the Satellite Controller, Attach the Satellite Controller