Filename [XV48EK_09Editing.fm]
Masterpage:Left0
48
Page 48 November 18, 2004 10:44 pm
REMOTE CONTROL
Remote Control Functions
Remote A/B/C/D Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four
codes (A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
On the remote control
Keep pressing VCR down during steps A–B.
AChange the remote control code.
Press the number key “1” for A, “2” for B, “3” for C, or
“4” for D.
BSet the remote control code.
Press ENTER to set the code.
On the unit
CTurn off the unit.
Press 1.
DDisplay the code.
Press 4 on the unit for over 5 seconds while the unit is
turned off. The code currently set appears on the front
display panel.
●If the code displayed on the front display panel is different
from the code set on the remote control, go to stepE.
EChange the unit’s code.
Press 8 on the remote control. The code currently set on
the remote control will be applied to the unit.
NOTE:
When “POWER SAVE” is set to “ON” (墌pg. 54), it is
impossible to change the remote code.
Before performing the following steps:
Slide the TV/VCR/DVD switch on the remote control to the
right.
Slide to the
right.
XV48EK_01.book Page 48 Thursday, November 18, 2004 10:45 PM