JVC LST0728-001B Memo :, Note :, Memo :,  Conditionally

	Item	Preset Values			Description
ERecording Settings (continued)
	Enable speedup	On motion		Enables you to specify whether to execute recording with a higher maximum frame rate when
		On event		motion is detected or when an event occurs.
				When [On event] is selected:
				Specify the starting and ending events in the [Start] and [Stop] fields respectively.
				The speedup recording frame rate uses the [Frame Rate] in the [Speedup Settings]A item.
	When to store	Always		Always	: Select this check box to record images at all times.
	images in	Never		Never	: Do not perform recording in the recording control mode. Record
	database
		 Conditionally			starts when the [REC/STOP] button is pressed.
				Enables you to specify the recording conditions in recording control mode. If you have
				selected [Conditionally], specify the following fields as well.
				On motion	: Select this check box to record all images for which motion has been
					detected.
				On event	: Select this check box to record all images from the occurrence of an
					event until the next event occurs regardless of motion. Specify the
					starting and ending events in the [Start] and [Stop] fields
					respectively.
				Memo :
				● For details on events, refer to [Camera Input/Output Port and Events] (A Page 95).
				Note :
				● The [ALARM] indicator on the front panel lights up regardless of the recording status when
				the motion or event specified in [When to store images in database] occurs. Press the
				[ALARM CLEAR] button to turn off the light of the [ALARM] indicator.
				( )seconds pre/post recordings on motion/event:
				You can record images preceding and following a detected motion or event. Specify the time
				interval to record in the number of seconds before and after the occurrence. (A Page 135)
				Memo :
				● Do not set to A0 secondsB.
				● If Offline is selected in [Scheduler...], images will not be recorded.
				● This setting has no impact on manual recording, emergency recording, and [EXT REC IN]
				recording.
F Datebase		^		Enables you to specify the database settings. (A Page 110)
	Settings
G Motion		^
	Detection
	Settings
	Motion Detection..		Enables you to specify the two parameters for motion detection, namely [Sensitivity] and
				[Motion Sensitivity]. (A Page 104)
	Motion Color..		Enables you to specify the color to be used for highlighting detected motion.

57