AnalogueTeletext, To operate Teletext

Contrast, Bright-1, Colour and Sharpness are described at Picture menu on page 27.

Setting PIP Size

•Using “ ” or “” button select PIP Size.

•Press “” or “” button to change PIP size. Two different PIP sizes are available.

Setting PIP Position

•Using “ ” or “ ” button select PIP Posi- tion.

•Press “” or “” button to change PIP posi- tion.

There are four different PIP positions.

Programme in the PIP window can be

changed by “ / ” , digit buttons or AV button. All EXT modes (Except EXT-3) are also available in PIP window. PIP window is

removed from the screen by “” button.

Source Menu

In the Main menu, select “Source” using

“ ” or “ ” button, then enter the Source menu by 3&(;7pressing6“” / “” or “OK” buttons.

Select the available sources of DIGITAL, TV, EXT-1, EXT-2, EXT-2 S, EXT-3, EXT-4, EXT- 4S or PC using “ ” or “ ” button and by

pressing “” / “” or “OK” buttons.

Sound in PC mode

•Connect the PC’s Audio output to the TV’s PC Audio In socket with an audio cable.

•On your remote control,using “ ” button to select sound source from TV, EXT-1, EXT-2, EXT-3, EXT-4, PC and DIGITAL op- tions.

•When PIP is displayed on the screen, “ ” button allows you to switch sound between PC and selected PIP source.

No-Signal and Out Of Range Detection (PC mode)

In PC Mode,as no menu is displayed,in case that there is no PC input to the TV, it is displayed an OSD message:

No input signal detected

then the power lamp turns to orange and PC will switch to PC standby mode. Press AV

button, digit buttons or “” / “” but- tons to exit standby mode.

In PC Mode, if the resolution and the vertical frequency is not supported by the concept, it is displayed an OSD message:

Signal out of range