JVC LVT0954-007A Connecting Speakers, To connect an outdoor AM antenna, To connect speakers

English

AM antenna

1	2
	ANTENNA
	AV
	COMPU
	LINK
	Vinyl-covered wire
	(not supplied)
	3
	AM loop antenna
	(supplied)

1If the cords are covered with insulation, remove the short section of insulation at the end of each cord by twisting and pulling it off.

2Connect the AM loop antenna to the AM LOOP terminals as illustrated.

3Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals or connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

To connect speakers

You can connect the speakers using the speaker cords.

	1
2	Speaker terminals		3,4
Red	SPEAKERS		Red
Speaker	RIGHT	LEFT	Speaker
	SPEAKER IMPEDANCE
cord	6~16Ω		cord
	Black		Black
INPUT			INPUT
Rear of the right			Rear of the left
speaker			speaker

1If the cords are covered with insulation, remove the short section of insulation at the end of each cord by twisting and pulling it off.

2Hold the clamp of the speaker terminal.

3Insert the end of the speaker cord into the terminal. Match the polarity of the speaker terminals: (+) to (+) and (–) to (–).

4Release your finger from the clamp.

IMPORTANT:

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•DO NOT connect more than one speaker to one speaker terminal.

9