JVC CA-UXQ3S CD Messages, Troubleshooting, CD message, Meaning, Possible solution, Problem, page

CD Messages

CD message	Meaning	Possible solution	Reference
CANNOT PLAY	You are trying to play back an unplayable CD or	Replace the CD.
	a CD that has many scratches.
CD NO DISC	No CD is loaded.	Place a CD on the CD tray.

Troubleshooting

Check the following points before contacting the JVC service center.

Problem	Possible cause	Possible solution	Reference
			page
No sound is produced	Improper connection.	Connect all cords properly as in	8
from the speakers.		"Connections".
	Headphones are connected.	Disconnect the headphone plug.	4
	The MP3 disc is recorded utilizing	This product cannot play back this type	–
	"packet writing".	of MP3 disc. Replace the disc.
The clock display is	The main unit is turned off	Reset the clock.	10
flashing.	because of a power cut. The
	power plug is disconnected.
CD playback does not	The CD is upside down.	Place the CD on the CD tray with the	16
start.		letter-printed surface facing up.
	Moisture has condensed on the	Leave the main unit turned on, wait for	2
	lens.	approximately 1 or 2 hours, and then
		operate the main unit.
A certain point cannot be	The CD is scratched or dirty.	Clean or replace the CD.	27
played back properly.
Certain tracks on an MP3	These tracks were recorded in a	This product cannot play back this type	–
disc cannot be played	format other than MP3 format.	of MP3 disc. Replace the disc.
back.
The volume of cassette	The head or capstans are dirty.	Clean the head or capstans.	27
tape playback is low.
You cannot record	The cassette tape is write-	Cover the write protect tag holes on the	21
cassette tape playback.	protected.	cassette tape with adhesive tape.
A radio broadcast cannot	No antenna is connected.	Connect an antenna.	6, 7
be received.
A whirring noise is	The main unit is located close to a	Place the main unit away from a TV,	2
produced.	TV, computer, or other electric	computer, or other electric appliance.
	appliance.
The timer does not	You did not set the clock.	Set the clock.	10
function.
	The main unit is turned on.	After setting the timer, turn off the main	24, 25
		unit.
You cannot operate the	The remote control batteries are	Replace the batteries with new	5
remote control.	running low.	batteries.
Operations are disabled.	The built-in microprocessor may	Disconnect the power plug, and then	–
	malfunction due to external	connect it back in.
	electrical interference.
When you turn on the	The internal cooling fan produces	The noise is not a malfunction. This is	8, 11
main unit, a noise comes	the noise as it rotates.	to prevent excessive heat.
out from the rear of the
main unit.

28