EN61

Digital Dubbing

It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

A

OFFY

A

L

P

M

5S

 

T

T W

START/STOP

 

W

 

button

PLAY

 

To AC outlet

 

 

STOP

PLAY

 

 

STOP

Power cord

RM-V705B

RM-V712U

 

To DC OUT jack

(provided)

(optional)

 

 

Video unit equipped

 

DC cord

with DV connector

 

 

Coupuler

 

 

Core filter

DV cable (optional)

 

To DV OUT/IN connector

 

To DV OUT/IN connector

Connector is under the cover.

1 CONFIRM POWER-OFF STATUS Make sure the camcorder's power is off.

2 MAKE CONNECTIONS

Connect the camcorder to your video unit equipped with a DV connector using the DV cable (optional) as shown in the illustration.

3 START PLAYBACK

Press the Play button (4) to play back the source tape.

4 START RECORDING

While watching the playback on the monitor, engage the DV connector-equipped video unit's record mode from the spot on the source tape you want to begin recording.

NOTES:

You cannot use the battery pack installed in the camcorder as the power supply since a digital signal is output/input from/to the DV OUT/IN connector only when using the AC Power Adapter/Charger or the optional AC Charger Station.

If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

For Digital Dubbing, this camcorder can be connected only to one device at a time. This camcorder can also be used as a recorder.

If a blank portion is played back during dubbing, an unusual image may be dubbed.

Even though the DV cable is connected correctly, sometimes the image may not appear in step 3. If the above occurs, turn off power and make connections again.

The image with Digital Zoom, Fade/Wipe Effects, P.AE/Effects and Snapshot is not output from the DV OUT/IN connector. Only the original playback image is output from it.

To use this camcorder as a recorder . . .

1.Select the recording mode (pg. 15).

2.Turn the Power Dial to “PLAY” while pressing down the lock button located on it.

3.Connect the DV cable as shown in the illustration and load a cassette to record on.

4.Press the START/STOP button to engage the Record-Pause mode. “DV IN” appears on the screen.

5.Press the START/STOP button to start recording. “DV IN” changes to “ DV IN ”.

6.Press the START/STOP button again to engage the Record-Pause mode. “DV IN ” returns to “DV IN”.

Page 61
Image 61
JVC LYT0152-001B Digital Dubbing, RM-V705B RM-V712U, Provided Optional Video unit equipped, Connector is under the cover