JVC LYT0191-001B specifications 32kHz 48kHz, See pages 28

34ENRECORDING

AdvancedFeatures(Cont.)

			FRAME				FULL			MULTI 4	MULTI 9
									PIN-UP
			5S	5SD				ANIM.
	PHOTO MODE	FRAME
	SCENE	5S	ON	OFF
	BEEP / TALLY	ON
	WIND CUT	OFF	OFF		ON
	SOUND MODE	32kHz
	ID NUMBER	06	32kHz			48kHz
	DEMO. MODE	OFF
			This number is necessary when connecting
			the camcorder to a computer [01 to 99].
4			OFF		ON
	RETURN

PHOTO MODE

See pages 28 and 29.

SCENE (5-Second Mode) (☞ pg. 26)

5S–Pressing START/STOP allows you to take a 5- second “clip”. Press repeatedly for a succession of short recordings.

5SD–If you record a 5-second clip within 5 minutes after the previous one, the end of the old scene dissolves and is replaced by the new scene over a 2-second period.

ANIM. (Animation)–Each time you press START/ STOP, a 1/8-second recording is taken. By using an inanimate object and changing its position between shots, you can record the subject as though it’s moving.

•Animation is not available in the LP mode. If you tried to record in the LP mode after setting ANIM., the recording mode indicator "LP" begins to blink, and recording goes on in the SP mode.

NOTE:

During use of SCENE effect, focus (☞ pg. 43) and exposure control (☞ pg. 44) enter Full Auto operation.

WIND CUT

When activated, this mode helps cut down on noise created by wind.

ON–When shooting in high winds, set to “ON” to reduce noise.

•“” appears.

•The quality of the sound will change. This is normal. OFF–This function is disabled.

NOTE:

The Wind Cut mode is disabled during Full Auto operation.

SOUND MODE

Sound signals can be sampled at 32 kHz or 48 kHz.

32 kHz–This setting enables recording of stereo sound on four separate channels, and is recom- mended for use when performing Audio Dubbing. 48 kHz–This setting enables recording of stereo sound on two separate channels.

NOTE:

A tape recorded at 48 kHz cannot be used for Audio Dubbing.

BEEP/TALLY

The beep sounds when the power is turned on or off, and at the beginning and end of recording. Tally lamp lights up during recording.

ON–To activate the beep and tally lamp. OFF–To turn off the beep and tally lamp.

NOTE:

When the Power Dial is set to “	A	”, Beep/Tally
remains as originally selected.

DEMO. MODE (Demonstration Mode)

This setting demonstrates certain functions such as P.AE/Effects (☞ pg. 42), etc., and can be used to confirm how these functions operate. When the camcorder is turned off, “DEMO. MODE” is set to “OFF”.

NOTE:

If a tape is in the camcorder, the Demo mode cannot be turned on.