ENGLISH
* About “Color Management Adjustment” |
| |
1 | Set the picture mode of the color management. |
|
2 | Select the color to be adjusted by color management. | 3 Select color adjustment. |
Picture Adjust | Picture Adjust |
> Color Management | > Color Management |
Off | Pause | Off |
|
| Off | Pause | Off |
|
|
Custom1 | Red |
|
|
| Custom1 | Red |
|
|
|
Custom2 | Yellow |
|
|
| Custom2 | Yellow |
|
|
|
Custom3 | Green |
|
|
| Custom3 | Green |
|
|
|
| Cyan |
|
|
|
| Cyan |
|
|
|
| Blue |
|
|
|
| Blue |
|
|
|
| Magenta |
|
|
|
| Magenta |
|
|
|
| All Reset |
|
|
|
| All Reset |
|
|
|
| Hue | 0 |
|
|
| Hue | 0 |
|
|
| Saturation | 0 |
|
|
| Saturation | 0 |
|
|
| Brightness | 0 |
|
|
| Brightness | 0 |
|
|
Exit | Operate | Back | Check | Before | Exit | Operate | Back | Check | Before |
MENU Select |
| BACK | TEST |
| MENU Select |
| BACK | TEST |
|
4 | Select the “Hue”, “Saturation” or “Brightness” using the | / | button. | |||
5 | Use the | / | button to adjust. |
|
|
|
| Hue | 7 | Check | After |
|
|
| TEST |
|
| |||
● You can switch between “Before” and “After” using the [TEST] button of the remote control. | ||||||
6 | To end |
|
|
|
|
|
BACK | BACK | BACK | Save Color Management? | OK | |
Yes |
| ||||
|
|
| No |
| |
●After selecting “Cinema 1”, “Cinema 2”, or “Cinema 3” from “Picture Mode”, and after adjusting “Advanced”, adjustment of brightness in each “Color Management” mode is not possible.
Picture Adjust > Lens Aperture
09Lens Aperture
(Dark)
10Reset
Reset the setting.
Input Signal > HDMI
11HDMI
Configures HDMI input signal.
|
| Auto | Automatically configures the input signals. |
| Input | Standard | Select this when the dynamic range of the input images is |
| |||
|
| ||
|
| Enhanced | Select this when the dynamic range of the input images is |
|
| ||
|
|
| |
|
| Auto | Automatically configures the input signals. |
|
| YCbCr(4:4:4) | Select this when the Y Cb Cr(4:4:4) video signals are |
| Color Space | input. | |
|
| ||
| YCbCr(4:2:2) | Select this when the Y Cb Cr(4:2:2) video signals are | |
|
| ||
|
| input. | |
|
|
| |
|
| RGB | Select this when the RGB video signals are input. |
| Control with HDMI | On | Enables CEC communications. |
| Off | Disables CEC communications. | |
|
|
●The setting is available only if the HDMI terminal is selected.
●For some source devices,“Auto (input)” will not function properly. In such cases, please use Standard Mode or Enhanced Mode.
●Abbreviation
CEC: Consumer Electronics Control
Getting Started
Preparation
Basic Operation
Settings
Troubleshooting
Others
35
