JVC RV-B55 LTD ÖTo change preset stations, Using the main unit, Using the remote control unit

Presetting the desired stations (using the remote control unit)

30 stations in the FM band and 15 stations in the AM (MW/LW) band can be preset as follows:

ÖExample: (Presetting an FM station broadcasting at 103.5 MHz to preset button “15”)

SLEEP

DOWN UP SET

AUX

REVERSE MODE

DISPLAY

		PROGRAM
	RANDOM
	AUTO	REPEAT
	PRESET
C D	TAPE	TUNER
		BAND
		FM MODE
REW	MULTI CONTROL	FF

SOUND ACS

4

1

2

3

MHz

1Press the TUNER BAND/FM MODE button.

2Select the FM band using the TUNER BAND/FM MODE button.

3Tune to the required station.

4Press preset button “+10”, then “5” for more than 2 sec.

(When “15” blinks in the preset station display, the station has been stored.)

ÖRepeat the previous procedure for each of the other stations, using a different preset button each time.

ÖRepeat the previous procedure for the other band.

ÖTo change preset stations

Perform step 4 after tuning to the required station.

Notes:

ÖThe previously stored station is erased when a new station is stored, because the new station’s frequency replaces the previous frequency in memory.

ÖWhen listening to an AM (MW/LW) broadcast, noise may be heard if the remote control unit is used.

To prevent the preset stations from being erased because of a power failure, etc., install memory back-up batteries in the unit (see page 6).

Preset station tuning (Receiving the preset stations)

ÖThe stations must be preset before this operation can be performed.

(Using the main unit)

1Press the TUNER BAND button.

2Select the band using the TUNER BAND button.

3Each time the PRESET TUNING button is pressed, the next preset station is selected.

(Using the remote control unit)

1Press the TUNER BAND/FM MODE button.

2Select the band using the TUNER BAND/FM MODE button.

3Press the required preset station buttons (No. 1 – No. 10 and +10). Ö The preset station number and frequency corresponding to the button

pressed are shown.

Using the antennas

FM

FM:Adjust the telescopic antenna’s length, angle and direction until optimum reception is received.

AM (MW/LW): Install the unit where suitable reception is possible (beside a window, etc.) or change the direction of the unit.

Note:

The built-in ferrite core antenna can pick up interference from television receivers in the neighborhood and thereby disturb AM (MW/LW) reception.

AM (MW/LW)

19