JVC RV-B55 BU Timer recording of broadcast, Operations, ÖTo repeat timer recording every day

Timer recording of broadcast

ÖThe current time must be set before the timer can be used.

ÖMake sure that the safety tabs of the cassette have not been broken off.

Operations

1	5		2
	ON/STANDBY
	AHB PRO	ACS	SOUND
	PRESET		ONE TOUCH
	AUX	TUNING	REC
	BEAT CUT		STANDBY AHB PRO	ACS
			OPEN

4

VOLUME

BAND

C D TAPE TUNER

MULTI CONTROL

REW STOP FF

3

		TIMER
CLOCK	TIMER ON/OFF

			SLEEP
DOWN	UP	SET
			PROGRAM
		RANDOM
		AUTO	REPEAT
		PRESET
AUX	C D	TAPE	TUNER
			BAND
			FM MODE
REVERSE MODE	REW	MULTI CONTROL	FF

1Set the button to ON.

2Load a cassette.

ÖInsert the cassette with the side to be recorded facing out.

ÖSelect the required reverse mode ( or ).

ÖSet the tape direction to 3 (forward) by pressing the TAPE 23 button.

3Set the timer. (Refer to “Setting the timer” on page 23.)

ÖSet the timer about a minute before the broadcast to be recorded is scheduled to start.

4Tune to the station to be recorded. (Refer to page 18.)

5Set the button to standby.

ÖConfirm that the timer mode indicator (REC ) is displayed in the display window.

ÖTimer recording will start at timer start time and the power will be switched off at timer stop time. (The timer mode is then released.)

ÖTo repeat timer recording every day

Press the TIMER ON/OFF button to display the timer mode indicator (REC ) in the display window.

ÖTo cancel timer operation

Press the TIMER ON/OFF button so that the timer mode indicator

(REC ) goes out.

If you do this, timer recording will not start at the timer start time.

Notes:

Once the timer has been set, the start and stop times, etc., are stored in memory. When timer recording or playback is required at different times, the timer must be set again.

ÖAfter setting the timer start and stop times, check that the tuner is tuned to the required frequency.

ÖIf memory back-up batteries are exhausted or not installed, and the power cord is disconnected or there is a power failure, timer settings will be erased from memory. If this happens, set the current time and perform the timer setting again.

24