JVC RV-B55 LTD, RV-B55 BU manual Handling Cassette Tapes, Repeat play using the remote control unit

Repeat play (using the remote control unit)

Press the REPEAT button before or during play. A single track or all the tracks can be repeated.

Whether a single track or all tracks are to be repeated can be specified. Each time the REPEAT button is pressed, the mode will change from single track (), to all tracks ( ALL), to clear mode, in this order.

REPEAT

	ALL	Goes off.
Single track	All tracks	Repeat playback is released.

ÖSingle track repeat ()

The current or specified track will be played repeatedly.

ÖAll tracks repeat ( ALL)

All tracks or the programmed tracks of a CD will be played repeatedly.

Random play (using the remote control unit)

Press the RANDOM button.

“RANDOM” appears in the display window. After all tracks are played back once in random order, playback stops and random play is released.

RANDOM

Note:

Move the unit as far away possible from a TV or other radio set. Otherwise, the CD playback sound will be degraded or the TV picture may be distorted.

HANDLING CASSETTE TAPES

Cassette tapes

1.Loose tape may cause trouble. Using a pencil or similar object, gently tighten the tape as shown.

2.To prevent recordings from being erased accidentally, remove the tab(s) with a screwdriver, etc. Reseal the slots with adhesive tape to erase and re-record after the tabs have been removed.

3.C-120 cassettes are not recommended because they are prone to malfunction.

Cassette loading

1.Turn the OPEN knob to the left to open the cassette holder.

2.Insert a cassette tape as shown on the next page.

3.Close the cassette holder.

Turn the pencil to tighten the tape.

Side “A”

Tab “B” Side “B” Tab “A” Adhesive tape

Note:

If the power is switched off while a tape is running, it may be impossible to remove the cassette. If this happens, switch the power on again before attempting to remove the cassette.

Auto tape select mechanism

This unit has an Auto Tape Select mechanism which distinguishes between different types of tape using detection holes in the cassette. After the type of tape has been detected, bias and equalization suitable for the tape are set.

ÖCassettes with detection holes:

Metal tape (EQ: 70 µs) .................... Type IV

CrO2 (chrome) tape (EQ: 70 µs) ..... Type II

ÖCassettes without detection holes:

Normal tape (EQ: 120 µs) ............... Type I

Metal/CrO2 tape detection holes

16