JVC RV-NB10B, RV-NB10W

■■

Recording

■

It should be noted that it may be unlawful to re-record

pre-recorded tapes, records, or discs without the

consent of the owner of copyright in the sound or

video recording, broadcast or cable programme and

in any literary, dramatic, musical, or artistic work

embodied therein.

■

When you want to record onto both sides of a tape, you can set

reverse mode to . Recording automatically stops after

recording in the reverse (2

) direction. Therefore, make sure that

the tape direction is forward (3

) when recording with reverse

mode is on.

■

The recording level is automatically set correctly, so it is not

affected by the VOLUME control on the system or by adjusting

the sound effects. Thus, during recording you can adjust the

sound you are actually listening to without affecting the

recording level.

■

Two small tabs on the back of the cassette tape, one for side A

and one for side B, can be removed to prevent accidental erasure

or recording.

■

To record on a cassette with the tabs removed, you must cover

the holes with adhesive tape ﬁrst. However, when a type II tape

is used, only cover part of the hole as shown, since the other part

of the hole (type II detection slot) is used to detect the tape type.

■

Type I and type II tapes can be used for recording.

Note:

At the start and end of cassette tapes, there is leader tape which

cannot be recorded onto. Thus, before recording, wind on the

leader tape ﬁrst to ensure getting the beginning of the recording.

CAUTION: If a recording you make has excessive

noise or static, the system may have been too

close to a TV which was on during the recording.

Either turn off the TV or increase the distance

between the TV and the system.

You can record any sound source to tape.

The sources are disc, tuner, auxiliary equipment, microphone, and

guitar. The microphone sound and guitar sound can be mixed with

any source.

■

1.Insert a blank or erasable cassette tape

into the cassette deck.

Be sure that the tape direction indicator and the tape insertion

direction are as follows:

[Forward and reverse recording]

•If the tape direction 2

(reverse) is lit, press TAPE 2

to change

the direction. (In this case, since the tape play starts, you need to

press 7

. Then, press 4

to rewind the tape up to the end point of

the leader tape which cannot be recorded onto.)

• If the inserted tape is not fully rewound, press 4

to rewind the

tape up to the end point of the leader tape which cannot be

recorded onto.

■

2.If you want to record on both sides of the

tape, press REVERSE MODE on the remote

control to set the cassette deck in reverse

mode.

Press the

button until “ ” is lit.

■

3.Prepare the source, for example, tuning in

to a radio station, or turning on the

connected auxiliary equipment.

Note:

For disc recording, refer to “Disc direct recording”

described on page 15.

Continued on the next page...

TAPE 2 3

ONE TOUCH REC

BEAT CUT

TAPE 2 3

REVERSE

MODE

CD 6

WIRELESS/

FM/AM

AUX WIRELESS/

FM/AM

CD 6

AUX

Things to know before you start

recording

Type II detection

slot

Adhesive tape

Standard recording

Tape direction indicator Tape insertion direction

(Forward)

Recording will be made on

the tape side facing you.

(Front view)

(Reverse)

Recording will be made on

the opposite side of the tape.

(Front view)

EN07-20_RV-NB10[J]2.fm Page 14 Thursday, January 12, 2006 2:27 PM