 
 18
 English
 ■■
 Using the microphone/guitar
 Using a microphone or a guitar (not supplied), you can mix its 
sound with a source sound.
 ■
 1.Make sure the MIC/GUITAR LEVEL control
on the rear of the system is properly set.
 • When using a microphone, make sure the knob is pressed in 
(_
 ).
• When using a guitar, make sure the knob is released (—
 ).
 ■
 2.Set the MIC/GUITAR LEVEL control to MIN
by turning it fully counterclockwise.
 ■
 3.Connect a microphone or a guitar into the
MIC/GUITAR INPUT jack on the rear of the
system.
 ■
 4.Start a source: disc, tape, tuner, or other
equipment.
 ■
 5.Adjust the VOLUME +/– control and the
MIC/GUITAR LEVEL control, as you play the
microphone or the guitar.
 CAUTION: DO NOT connect a bass guitar to the 
MIC/GUITAR INPUT jack, as it may damage the 
system.
 ■
 1.Follow the above steps – .
■
 2.To record, follow the steps in “Standard
recording.” (See page 14.)
 Note:
 If “howling” occurs when using the microphone, keep the 
microphone away from the speaker.
 ■■
 Using the timer
 The timers let you control the listening and recording functions automatically.
When the power is first supplied, the CLOCK indicator and 
“AM12:00” flash on the display. Set the clock.
 Note:
 The clock must be correctly set for the timers to work.
 ■
 1.Press ON/STANDBY.
 ■
 2.Press CLOCK/TIMER repeatedly until the
CLOCK indicator lights up.
 The hour digit flashes on the display.
 ■
 3.Press ¢
 or 4
to select the hour.
• When you press and hold the button, the hour digit changes 
continuously.
 ■
 4.Press SET to set the hour.
 The minutes digits start flashing on the display.
 ■
 5.Press ¢
 or 4
to select the minute.
•When you press and hold the button, the minute digit changes 
continuously.
• If you want to change the hour setting, press CANCEL.
 ■
 6.Press SET to finish setting the clock.
 CAUTION: If memory backup batteries are 
exhausted or not installed, and the AC power 
cord is plugged in again after being 
disconnected, or power is restored after a power 
failure, the CLOCK indicator will flash on the 
display. Set the current time (clock) again.
 Microphone/guitar mixingRecording microphone or guitar mixing on a tape
4¢
CLOCK/TIMER
SET
CANCEL
SLEEP
 ON/STANDBY 
Setting the clock
 Using the remote control only
RV-NB10[C].book Page 18 Saturday, January 21, 2006 11:33 AM