JVC RX-7000RBK Using the SEA Modes, Selecting Your Favorite SEA Mode, Creating Your Own SEA Mode

Using the SEA Modes

The SEA (Sound Effect Amplifier) modes give you control of the way your music sounds.

English

IMPORTANT:

When using the remote control, check to see if its

remote control mode selector is set to the correct

AUDIO/

position:TV/VCR

To operate this receiver, set it to “AUDIO/TV/

CATV/DBS

VCR”.

Selecting Your Favorite SEA Mode

On the front panel:
Press SEA MODE repeatedly until the SEA	SEA MODE
mode you want appears on the display.

•Each time you press the button, the SEA mode changes as follows:

SEA ROCKSEA MUSICALSEA MOVIE

SEA COUNTRY

SEA OFF SEA USERMODE SEA JAZZ

Creating Your Own SEA Mode

You can adjust and store your own SEA adjustment into memory (SEA USERMODE).

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

If you do not want to store your adjustment, but rather want to adjust the SEA temporarily, skip step 4 below.

1. Press SEA ADJUST repeatedly	SEA ADJUST
until the frequency range (100 Hz,
1 kHz or 10 kHz) you want
appears on the display.

SEA ROCK:Gives a heavy sound. Both high and low frequencies are boosted.

SEA MUSICAL: Enhances the mid-frequency range, which the human voice is mostly made up of.

SEA MOVIE: Adds breadth to sounds so you feel like you are in a movie theater.

SEA COUNTRY: Enhances the high-frequency range so that instruments such the violin and banjo are emphasized.

SEA JAZZ:Gives a feeling of a live atmosphere. Good for acoustic music.

SEA USERMODE: Your original SEA adjustment (see the right).

SEA OFF:No SEA mode is applied (see below).

Notes:

•The SEA modes cannot be used for recording.

•When the SEA mode is turned on, the SEA indicator lights up on the display.

•When the SEA mode is used with the DAP mode (see page 28), sounds may be distorted. If this happens, turn off the DAP mode or decrease the effect level of the DAP mode.

2. Turn MULTI JOG to adjust the	MULTI JOG
SEA level of the selected frequency
range.

•Turning it clockwise increases the level.

•Turning it counterclockwise decreases the level.

3.Repeat steps 1 and 2 to adjust other frequency ranges if necessary.

4.Press (TUNER/) SEA MEMORY. TUNER/SEA MEMORY

Your adjustment is stored into the SEA

USERMODE.

To cancel the SEA mode

Press SEA MODE repeatedly until “SEA OFF” appears. The SEA indicator goes off from the display.

To recall your own SEA adjustment

Press SEA MODE repeatedly until “SEA USERMODE” appears.

From the remote control:

1. Press SOUND.

The 10 keys are activated for sound adjustments.

2.Press SEA MODE repeatedly until the SEA mode you want appears on the display.

To cancel the SEA mode

SOUND

SEA MODE

10

RETURN

To erase a stored adjustment

Storing a new adjustment into SEA USERMODE erases the previously stored one.

Press SEA MODE repeatedly until “SEA OFF” appears in step 2 above. The SEA indicator goes off from the display.

24