English
Troubleshooting
Use this chart to help you solve daily operational problems. If there are any problems you cannot solve, contact your JVC’s service center.
|
| PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
| The power does not come on. | The power cord is not plugged in. | Plug the power cord into an AC outlet. | |
|
| ||||
|
|
|
|
| |
|
| No sound from speakers. | Speaker signal cables are not connected. | Check speaker wiring and reconnect if necessary. | |
|
|
|
|
|
|
|
|
| An incorrect source is selected. | Select the correct source. |
|
|
|
|
|
| |
|
|
| Muting is activated. | Press MUTING to cancel the mute. | |
|
|
|
|
| |
|
|
| An incorrect input mode (analog or digital) | Select the correct input mode (analog or digital). | |
|
|
| is selected. |
|
|
|
|
|
|
|
|
|
|
| Connections are incorrect. | Check connections. |
|
|
|
|
|
| |
|
| Sound from one speaker only. | The balance is set to one extreme. | Adjust the balance properly (see page 22). | |
|
|
|
|
|
|
|
| The STANDBY lamp lights up after | Speakers are overloaded because of high | 1. Press STANDBY/ON | on the front panel to turn |
|
| turning on the power, but soon the unit | volume. | off the unit. |
|
|
| turns off (into standby mode). |
| 2. Stop the playback source. | |
General |
|
|
| 3. Turn on the unit again, and adjust the volume. | |
|
|
|
| ||
|
| short circuit at the speaker terminals. | If speaker wiring is not | ||
|
|
| Speakers are overloaded because of a | Check the speaker wiring. |
|
|
|
|
| dealer. |
|
|
|
|
|
| |
|
|
| The unit is overloaded because of a high | Consult your dealer after unplugging the power cord. | |
|
|
| voltage. |
|
|
|
|
|
|
| |
|
| Remote control does not operate as | The remote control is not ready for your | Press a source selecting button or TONE first, then | |
|
| you intend. | intended operation. | press the buttons you want to use. (See pages 21 | |
|
|
|
| and 34 – 37.) |
|
|
|
|
|
|
|
|
| Remote control does not work. | There is an obstruction hiding the remote | Remove the obstruction. |
|
|
|
| sensor on the unit. |
|
|
|
|
|
|
|
|
|
|
| Batteries are weak. | Replace batteries. |
|
|
|
|
|
| |
|
|
| The mode selector is set to the incorrect | Set the mode selector to the proper position. | |
|
|
| position. |
|
|
|
|
|
|
| |
|
| Bass sound is reinforced too much | Appropriate bass level is not selected. | Adjust audio position level (see page 22). | |
|
| when listening in stereo. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
38