JVC RX7030VBK manual Ls Rs

English

Speaker and signal indicators on the display

By checking the following indicators, you can easily confirm which speakers you are activating and which signals are coming into this receiver.

Selecting different sources for picture and sound

While watching pictures from a video source, you can listen to sound of an audio source.

Speaker indicators

L C R

SUBWFR

LS RS

SB

Signal indicators

L C R

LFE

LS S RS

SB

•Once you have selected a video source, pictures of the selected source are sent to the TV until you select another video source.

Press one of the audio source selection buttons while viewing the picture from a video component such as the VCR or DVD player, etc.

For RX-8030VBK		CD	FM/AM
		CDR	TAPE/MD
PHONO CD CDR TAPE/MD FM	AM	PHONO

What speaker indicators light depends on the speaker setting (for details, see “Setting the Speakers” on page 27).

•The frames of “L,” “C,” “R,” “LS,” “RS, ” and “SB” light up, when the corresponding speakers are set to “LARGE” or “SMALL” and when the speaker is required for the Surround/DSP mode currently selected.

•When “SUB WOOFER” is set to “YES,” SUBWFR lights up (see page 27).

•All three frames on the row of “SB” are not used at the same time. When “SBACK OUT” is set to “2SPK,” the left and the right ones are used. When it is set to “1SPK,” the middle one is used (see page 27).

The signal indicators light up to show the incoming signals. L: • When digital input is selected: Lights up when the left

channel signal comes in.

•When analog input is selected: Always lights up.

R: • When digital input is selected: Lights up when the right

channel signal comes in.

•When analog input is selected: Always lights up.

C: Lights up when the center channel signal comes in.

LFE: Lights up when the LFE channel signal comes in.

LS: Lights up when the left surround channel signal comes in.

RS: Lights up when the right surround channel signal comes in.

S: Lights up when the monaural surround channel signal comes in.

SB: Lights up when the surround back channel signal comes in.

Note:

When “DVD MULTI” is selected as the source, “L,” “C,” “R,” “LFE,” “LS,”

and “RS” light up.

How to understand the speaker and signal indicator illumination

L	C R	Ex. No sound comes out of the
SUBWFR LFE		center speaker and surround
		back speakers though center
LS	RS	channel and surround back
		channel signals are coming

into this receiver.

SB

		On the unit			On the remote
For RX-7030VBK
					CD FM/AM
	CD	TAPE/CDR	FM	AM	TAPE/CDR
		On the unit			On the remote

Note:

When you see the picture through the COMPONENT VIDEO jacks,

you cannot use this function.

Adjusting the Volume

On the front panel:

To increase the volume, turn MASTER VOLUME clockwise. To decrease the volume, turn it counterclockwise.

From the remote control:

To increase the volume, press VOLUME +.

To decrease the volume, press VOLUME –.

CAUTION:

Always set the volume to the minimum before starting any sources. If the volume is set at its high level, the sudden blast of sound energy can permanently damage your hearing and/or ruin your speakers.

Notes:

•The volume level can be adjusted within the range of “0” (minimum) to “70” (maximum).

•If you set One Touch Operation to “ON” (see page 30), you do not have to adjust the volume level each time you change the source. It is automatically set to the stored level.

18