JVC RX7030VBK manual Basic Settings

Basic Settings

Some of the following settings are required after connecting and positioning your speakers while others will make operations easier. You can use QUICK SPEAKER SETUP to easily set up your speaker configuration.

English

Setting the Speakers Configuration Remote

NOT

Quick Speaker Setup helps you to easily and quickly register the speaker size and speaker distance according to your listening room to create the best possible surround effect.

•You can also register each speaker’s information manually. For details, see page 27.

3. Press in MULTI JOG (PUSH SET).

“ROOM SIZE?” appear on the display, then the initial room size setting appears.

ANALOG

L R LINEAR PCM

SPEAKERS 1

VOLUME

ANALOG

L R LINEAR PCM

SPEAKERS 1

VOLUME

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel:

1. Press QUICK SPEAKER SETUP.

“SETUP” and “SPEAKERS?” appear on the display, then the initial setting for the total number of the connected speakers (channels) appears.

ANALOG

L R LINEAR PCM

SPEAKERS 1

VOLUME

4. Turn MULTI JOG to select an appropriate room size to match to your listening room.

The room size changes as follows.

•To select your appropriate room size, see “Room size and the speaker distance” on page 26.

ANALOG

L R LINEAR PCM

SPEAKERS 1

VOLUME

SMALL “ MID “ LARGE* “ (Back to the beginning)

* “LARGE” is the initial setting.

ANALOG

L R LINEAR PCM

SPEAKERS 1

VOLUME

2.Turn MULTI JOG to select an appropriate number of the connected speakers (speaker

channel number).

The speaker channel number changes as follows.

•For the details of speaker channel number, see “Speakers (channels) number and the size” on page 26.

ANALOG

L R

SPEAKERS 1

VOLUME

2.0CH “ 2.1CH “ 3.0CH “ 3.1CH “ 4.0CH “ 4.1CH “ 5.0CH “ 5.1CH “ 6.0CH* “ 6.1CH “ 7.0CH “ 7.1CH “ (Back to the beginning)

5. Press in MULTI JOG (PUSH SET).

“COMPLETE” appears on the display, then goes back to the source indication.

•Speaker configuration settings now become active.

ANALOG

L R LINEAR PCM

SPEAKERS 1

VOLUME

Note:

This procedure will not be completed if you stop in the middle of the setting process.

* “6.0CH” is the initial setting.

25