JVC TH-L1 References, Troubleshooting, POWER, SOUND, REMOTE, PROBLEM, CONTROL, PICTURE, SOLUTION, PLAYBACK, POSSIBLE CAUSE

References

Troubleshooting

	PROBLEM	POSSIBLE CAUSE	SOLUTION
	Power does not come on.	The power cord is not connected.	Connect the power cord correctly.
POWER			(See page 13.)
	The system suddenly	The playback level of the current	Play back the source with lower
	turns off.	source is too high.	volume level.
	The remote control does	The batteries are exhausted.	Replace the batteries. (See page 6.)
	not work.
		Sunlight is shining directly on the	Hide the remote sensor from direct
REMOTE		remote sensor.	sunlight.
CONTROL
	The remote control does	The remote control mode is not for	Before operation, press one of the
	not work as expected.	the desired source.	source selecting buttons for the
			desired source.
	No sound.	The speaker cord is not connected.	Check the connection. (See page 7.)
SOUND
		An incorrect source has been selected.	Select the correct source. (See page
			16.)
	No picture is displayed on	The video cord is not connected	Connect the cable correctly. (See page
	the TV screen.	correctly.	9.)
		The file is not playable.	Use a playable file. (See pages 3.)
	No picture is displayed on	The connected TV is not HDCP-	Use a HDCP-compatible TV.
	the TV or no sound come	compatible.
	out through HDMI
		The HDMI cord is not connected	Disconnect the HDMI cable and
	connection.
PICTURE		correctly.	connect it again.
	No picture is displayed on	The scanning mode is set to “PAL	Change the scanning mode to “PAL”
	the TV screen, the picture	PRG” or “NTSC PRG” though the	or “NTSC”. (See page 18.)
	is blurred, or the picture is	center unit is connected to the TV
	divided into two parts.	which does not support the
		progressive video input.
	The picture does not fit	The monitor type is not set correctly.	Set “MONITOR TYPE” properly. (See
	the TV screen.		page 29.)
	The iPod does not play	The battery of the iPod is exhausted.	Leave the iPod connected for at least
	even though		10 minutes.
	“CONNECT” appears on
		The iPod battery charge function is	Activate the iPod battery charge
	the display.
		deactivated.	function. (See page 20.)
		The iPod is not compatible with the	Check the compatibility on the list.
		System.	(See page 19.)
	The iPod is not charged.	The source is not “iPod.”	Change the source to “iPod.” (See page
			16.)
PLAYBACK		The iPod battery charge function is	Activate the iPod battery charge
		deactivated.	function. (See page 20.)
	Video and audio are	A video component is connected	Connect the center unit and TV
	distorted.	between the center unit and the TV.	directly. (See page 9.)
	Surround modes of	“ANALOG” is selected on the setting	Select “DIGITAL” on the setting of the
	“DOLBY DIGITAL” or	of the audio terminals.	audio terminals.
	“dts SURROUND” are not
		The external component is not	Connect the external component with
	available to use.	connected with the digital audio cord	the digital audio cord (coaxial or
		(coaxial or optical) or HDMI cord.	optical) or HDMI cord. (See pages 10
			to 12.)

32