Introduction

Safety Precautions

Information for Users on Disposal of Old Equipment [European Union]

This symbol indicates that the electrical and electronic equipment should not be disposed as general household waste at its end-of-life. Instead, the product should be handed over to the applicable collection point for the recycling of electrical and electronic equipment for proper treatment, recovery and recycling in accordance with your national legislation.

 

 

 

By disposing of this product correctly, you will help to conserve natural resources

 

 

 

and will help prevent potential negative effects on the environment and human

 

 

 

health which could otherwise be caused by inappropriate waste handling of this

 

 

 

product. For more information about collection point and recycling of this product,

 

 

 

please contact your local municipal office, your household waste disposal service

Attention:

or the shop where you purchased the product.

Penalties may be applicable for incorrect disposal of this waste, in accordance

This symbol is

with national legislation.

only valid in the

(Business users)

European Union.

If you wish to dispose of this product, please visit our web page

 

 

 

 

 

 

www.jvceurope.com to obtain information about the take-back of the product.

 

 

 

[Other Countries outside the European Union]

 

 

 

If you wish to dispose of this product, please do so in accordance with

 

 

 

applicable national legislation or other rules in your country for the treatment of

 

 

 

old electrical and electronic equipment.

I

INFORMATION FOR USA

INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the

equipment and receiver.

Connect the equipment into an outlet on a

 This installation should be made by a qualified

service person and should conform to all local

codes.

 This installation shall be in accordance with

the National Electrical Code, ANSI/NFPA 70.

 Any Mention in this manual of Alarm inputs

have not been evaluated by UL to be used for

Burglar Alarm Functionality.

 Embedding of cameras in the ceiling may not

be allowed due to regulations in some

regions. Please consult your nearby

authorized JVC dealer for more details.

 The ceiling to mount the camera has to be

strong enough to support the weight of this

product. If the ceiling is not strong enough,

make sure to apply reinforcement to the

ceiling before installation.

 Be sure to tighten the screws and nuts

securely, Insufficient tightening may cause the

unit to fall from its mount.

 The rating label is displayed on the side of the

camera unit.

 The camera unit may fall if the mounting

screws and nuts are not properly tightened.

Ensure that the screws and nuts are properly

tightened.

 We do not accept liability for any damage to

FOR USA AND CANADA

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS

INSIDE.REFER SERVICING TO

QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated Adangerous voltageB within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

Due to design modifications, data given in this instruction book are subject to possible change without prior notice.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

AVERTISSEMENT:

POUR EVITER LES RISQUES D'INCENDIE OU D'ELECTROCUTION, NE PAS EXPOSER L'APPAREIL A L'HUMIDITE OU A LA PLUIE.

INFORMATION (FOR CANADA) RENSEIGNEMENT (POUR CANADA)

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numerique de la Class Best conforme a la norme NMB-003 du Canada.

circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/

TV technician for help.

CAUTION

CHANGES OR MODIFICATIONS NOT APPROVED BY JVC COULD VOID USER'S AUTHORITY TO OPERATE THE EQUIPMENT.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.

OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

The unit is to be powered by a DC 12 V or an AC 24 V power supply.

The unit is to be powered by a UL Listed DC 12 V or an AC 24 V power supply. (For U type)

The AC 24 V and 12 V DC power supply shall conform to the following: Class 2 only (For USA), Isolated power supply only (For Europe).

the camera in cases when it is dropped

because of incomplete installation due to not

observing the installation instructions

correctly. Please be careful when installing the

camera.

 Do not install the camera near lighting

equipment with a high temperature, such as

spotlights. Doing so may cause malfunction or

fire.

 Before starting an important recording, be

sure to perform a test recording in order to

confirm that a normal recording is possible.

 We will not provide any compensation

whatsoever for the contents to be recorded or

loss of opportunities when recording is not

properly performed due to malfunction of the

video camera, VTR, hard disk recorder or

video tape.

 Prior to adjusting the shooting direction of the

camera, touch the metal surface of the

[MONITOR] terminal with your hand to

discharge static electricity from your body.

2

3

Page 2
Image 2
JVC TK-C210FW manual Safety Precautions, Business users, Other Countries outside the European Union