Introduction (continued)
Name of Parts
Camera
I
H
G
A | F |
| |
| B |
B | E |
| |
C |
|
Camera (Interior)
The picture below shows the camera when the dome cover and outer case are removed. Procedures for removal. (A pg. 18 AEmbedding the camera to the ceilingB, Step 3. to Step 4.)
U
Lens
(A Next page)
Camera Unit (Rear)
TV
S
R 
N
Q P
J
A
K 
O
L
N
E Wiring Hole
Break and use this when drawing the cable from the camera unit without drilling a hole in the ceiling. (A pg. 22)
F Input Power cable
M
D
A Mounting hole (elliptical) x 4
Use these when mounting the camera to the electrical box. (A pg. 22)
NOTE:
When installing the camera onto the electric box, install it using the supplied adaptor ring.
B Mounting hole (round) x 4
Use these when mounting the camera to the ceiling or wall. (A pg. 18, 20)
C Outer Case
Use this in the following cases:
●When mounting the camera directly to the ceiling or on the wall. (A pg. 20)
●When mounting the camera to the electrical box. (A pg. 22)
D Dome Cover
The dome cover is fragile. Take care when handling it.
DC 12 V Input: Red (+12 V), Black (GND)
AC 24 V Input:
G Alarm signal cable
Yellow (ALARM IN), Gray (ALARM GND). (A pg. 15)
H Protection Cover
Upon connecting the coaxial cable, protect it by insulating the metal part of the BNC connector from the ceiling structure.
I Video signal output connector (BNC)
(A pg. 14)
J Fastening Screw (x 3)
Screw head of the ceiling mount bracket O to be used when embedding the camera to the ceiling.
K [MONITOR] terminal (RCA pin)
(A pg. 23)
L Camera Unit
M Fall Prevention Wire Fastening Hook
N Fall Prevention Wire (Supplied) and Wire Mounting Screw
Connect the camera unit L and the outer case C using the fall prevention wire fastening hook M.
O Ceiling Mount Bracket (x 3)
This is used as a bracket when embedding the camera to the ceiling. (A pg. 18)
P Camera Fastening Screw
Use this to fasten the camera unit L to the outer case C. To remove. (A pg. 18, 20)
Q Tilt Lock screw
Tighten the screw to ensure that camera's shooting direction does not go out of alignment when it is used in a location with strong vibration. (A pg. 24)
R Imaging Direction mark
Install the camera by aligning the imaging direction with the arrow mark.
S Rotation Knob
Rotate the lens unit to adjust the inclination of the image (to be turned).
T Rotation Center Mark
(A pg. 24)
U Pan fastening Screw
Ensure to loosen the screw before setting. Further tighten the screw to ensure that camera's shooting direction does not go out of alignment only when it is used in a location with strong vibration. (A pg. 24)
V Fall Prevention Wire mounting hole & Screw
(Fall Prevention Wire not included.)
8 | 9 |
