Fall Prevention | JVC TK-WD31 manual

SEE INST-		DC12V
RUCTION		AC24V	1	2
MANUAL
CLASS 2 ONLY (UTYPE)
ISOLATED POWER ONLY
		(ETYPE)
POWER	VIDEO OUT		SET	SELECTOR
POWER	VIDEO OUT
LL	INT

6mm

2mm

M3 ⋅ 6

Fall Prevention

•Exercise maximum caution when installing the unit to the wall or ceiling. You should not engage in the installation work yourself. Ask a professional to do the job, since the fall of the unit can result in injuries and accidents.

•When installing the unit on a fixer, Pan/Tilt unit, etc., make sure to install it firmly using a rotation-preventing hole provided to prevent fall.

•To prevent fall, connect the unit to a section with sufficient strength (ceiling slab or channel) using a fall prevention wire such as a wire chain and the like. Use the black screw on the back of the unit for installation.

For the used safety cable, pay particular caution to the length, strength, pull, material (insulation), etc.

•Specified screw (M3 ⋅ 6 mm)

Never use any screw longer than the specified length as the inside can be damaged.

19

Image 25

JVC TK-WD31 manual Fall Prevention

Contents

LWT0181-001B-H Color Video Camera TK-WD310INSTRUCTIONS Important Safeguards Page III Page Safety Precautions Page Introduction Features Reference page or item Memo Contents Operating Precautions Introduction Page Names and Operations of Parts Backfocus adjustment ringFront and Bottom Lens mount Use a screw shorter than 7 mm. Camera-mounting bracketRotation prevention hole Power Power indicator lamp Video OUT Video signal output connectorThis lamp lights when power is supplied to the camera Rear Panel Selector button SET buttonThis is set for internal synchronization INT Side Panel VIDEO/DC Iris Selector SwitchIris Iris Terminal This is connected to an automatic iris control lens. System with up to 8 cameras Basic System Mounting the lens Mount the lens according to the procedures described below Video DC Iris Video IrisGND Connections on the back Power supply DC 12 V or AC 24 Conductor diameter Φmm More 100 m 260 m 410 m 500 m Reference Mounting the camera Fall Prevention Auto iris lens adjustment Level turning direction Level adjustmentToo bright Too dark Clockwise Toward H Back focus adjustment With a zoom lens With a fixed-focus lens Operation Menu settings C M OD E Menu screens are structured as shown below Menu tree Default setting OFF Focus Adjust screenAbout menus Mode WDR Mode Video Adjust screen WDR Mode Wide Dynamic Range WDR is adjusted manually WDR Bias ContentWDR Limit EXP. Bias Setting Gain AGC Mode Memo White Balance Default setting ATW Preparation Manual This setting is performed when using the DC auto iris lens Camera Settings screenColor Level Enhance Level Camera Title PhaseDC Gain DC Offset Repeat steps 4. and 5. above to enter up to 24 characters Camera Title Edit screen Allowed characters Returns set values to their factory settings Factory Settings screenClear Symptom Remedy TroubleshootingOperation becomes un Ultra Super High MID LOW OFF MAX MIN Video OUT SpecificationsLx 50%, F1.2, AGC High Lx 50%, F1.2, AGC ULTRA⋅16 TK-WD310 Color Video Camera