Manuals / JVC / Photography / Security Camera

JVC TK-WD31 manual Back focus adjustment

Models: TK-WD31

1 48

Download 48 pages 31.33 Kb

Page 28

CONNECTION/INSTALLATION

Back focus adjustment

Be sure to make back-focus adjustments when changing the lens mount- ing method or using a different lens.

●To make accurate back focus adjustments, carry out adjustments in a state where the lens iris is released.

To open the lens iris, set MODE in the FOCUS ADJUST menu screen to ON. ( Page 27)

●The auto iris lens may operate under extremely bright conditions (7000lx or higher). In this case, use an ND filter to adjust the amount of light.

(The ND fiter acts to reduce the amount of incident light entering the lens evenly over the entire wavelength band.)

Lens focus ring

Back focus adjust ring

Phillips screwdriver

Back focus locking screws

Memo

If the iris cable length of the lens is insufficient when turning the back focus adjustment rings, lock the back focus locking screws, turn the lens and loosen the back focus locking screws again for achieving back focus.

22

Image 28

JVC TK-WD31 manual Back focus adjustment

Contents

Color Video Camera TK-WD310INSTRUCTIONS LWT0181-001B-HImportant Safeguards Page III Page Safety Precautions Page Features IntroductionMemo Reference page or itemContents Operating Precautions Introduction Page Names and Operations of Parts Backfocus adjustment ringFront and Bottom Lens mount Use a screw shorter than 7 mm. Camera-mounting bracketRotation prevention hole Video OUT Video signal output connector Power Power indicator lampThis lamp lights when power is supplied to the camera Rear PanelSelector button SET buttonThis is set for internal synchronization INT VIDEO/DC Iris Selector Switch Side PanelIris Iris Terminal This is connected to an automatic iris control lens.Basic System System with up to 8 camerasMount the lens according to the procedures described below Mounting the lensVideo DC Iris Video IrisGND Power supply DC 12 V or AC 24 Connections on the back100 m 260 m 410 m 500 m Reference Conductor diameter Φmm MoreMounting the camera Fall Prevention Auto iris lens adjustment Level adjustment Level turning directionToo bright Too dark Clockwise Toward HBack focus adjustment With a fixed-focus lens With a zoom lensMenu settings OperationC M OD E Menu tree Menu screens are structured as shown belowFocus Adjust screen Default setting OFFAbout menus ModeVideo Adjust screen WDR ModeWide Dynamic Range WDR is adjusted manually WDR ModeContent WDR BiasWDR Limit EXP. BiasAGC Mode Setting GainMemo Default setting ATW White BalanceManual PreparationCamera Settings screen This setting is performed when using the DC auto iris lensColor Level Enhance LevelPhase Camera TitleDC Gain DC OffsetCamera Title Edit screen Repeat steps 4. and 5. above to enter up to 24 characters Allowed characters Returns set values to their factory settings Factory Settings screenClear Troubleshooting Symptom RemedyOperation becomes un Ultra Super High MID LOW OFF MAX MINSpecifications Video OUTLx 50%, F1.2, AGC High Lx 50%, F1.2, AGC ULTRA⋅16TK-WD310 Color Video Camera