Listening to FM and AM Broadcasts

English

Setting the Tuner Interval Spacing

You can select 10 kHz or 9 kHz apart for the AM tuner interval spacing and 100 kHz or 50 kHz apart for the FM tuner interval spacing.

• You need to do this setting separately for each band.

On the unit ONLY:

1 Press TUNER/BAND to select either TUNER

/BAND

“FM” or “AM.”

The unit automatically turns on and tunes in to the previously received station—either FM or AM.

•Each time you press the button, the band alternates between FM and AM.

2 Press

STANDBY/ON

 

while holding down 7.

CD

• Each time you press

 

 

CONTROL

STANDBY/ON, the interval

 

spacing alternates as follows:

 

While selecting the AM tuner

 

10K (10 kHz) Ô9K

(9 kHz)

STANDBY/ON

 

While selecting the FM tuner

100K (100 kHz) Ô50K (50 kHz)

Tuning in to a Station

1 Press TUNER/BAND to select either TUNER

/BAND

“FM” or “AM.”

The unit automatically turns on and tunes in to the previously received station—either FM or AM.

•Each time you press the button, the band alternates between FM and AM.

2 Press and hold ¢or 4 (or ¡/¢or 4/1on the unit) for more than 1 second.

•

¢(¡/¢):

Increases the frequencies.

•

4(4/1):

Decreases the frequencies.

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

•If an FM program is broadcast in stereo, the ST (stereo) indicator lights up on the display (only when the reception is good).

To stop during searching, press ¢or 4(or ¡/¢or 4/1on the unit).When you repeatedly press ¢or 4(or ¡/¢or 4/1on the unit)

The frequency changes step by step.

When you change the setting

The preset stations are erased. You will need to preset the stations again. (See page 11.)

To change the FM reception mode

On the remote control ONLY:

When an FM stereo broadcast is hard to receive REPEAT

ST/MONO

or noisy, press REPEAT ST/MONO so that the MONO indicator lights up on the display. Reception will improve.

To restore the stereo effect, press REPEAT ST/MONO again so that the MONO indicator goes off. In stereo mode, you can hear stereo sound when a stereo program is broadcast.

To reduce the beat—Beat Cut

On the remote control ONLY:

If the beats are heard while listening a

BEAT CUT

broadcast, press BEAT CUT.

 

 

 

10