Basic and Common Operations

Continued

 

 

English

Setting the Clock

Before operating the unit any further, first set the unit’s clock. When you plug in the power cord, “0:00” starts flashing on the display.

To select 12-hour or 24-hour clock system

You can select 12-hour or 24-hour for the clock system only while the unit is in standby mode.

You can set the clock when the unit is either turned on or in standby mode.

•In the following procedure, the clock is set to 24-hour system.

On the remote control ONLY:

1

When the unit is in standby mode,

PROGRAM

 

 

 

 

press and hold PROGRAM until the

 

 

 

 

 

 

 

On the unit ONLY:

To change the clock setting, press TIMER ON/OFF while holding down 7.

•Each time you press TIMER ON/OFF, the clock change alternates between 12-hour and 24-hour system.

CD

CONTROL

TIMER ON/OFF

hour indication starts flashing.

•When the unit is on, press DISPLAY/CLOCK SET to enter clock mode, then press and hold PROGRAM.

To show the clock when the unit is turned on

On the remote control ONLY:

Press DISPLAY/CLOCK SET.

DISPLAY

 

/CLOCK SET

• Each time you press the button, the display changes the clock indication and the normal indication alternately.

2 Press 4or ¢to adjust the hour, then press

PROGRAM.

• When you press and hold 4or ¢, the hour indication changes continuously.

The minute indication start flashing.

PROGRAM

To change the clock
Repeat steps 1 to 3 of the procedure “Setting the Clock.”

Turning On the Power

To turn on the unit, press STANDBY/ON.

The STANDBY lamp on the unit goes off.

STANDBY/ON

3 Press 4or ¢to adjust the minute, then press

PROGRAM.

•When you press and hold 4or ¢, the minute indication changes continuously.

The built-in clock starts.

PROGRAM

•When you press the source button—TAPE, TUNER/BAND and CD, the unit automatically turns on.

To turn off the unit (standby), press STANDBY/ON

again.

The STANDBY lamp on the unit lights red.

•“0:00” flashes on the display until you set the built-in clock. After setting the clock, the clock time will appear on the display while the unit is on standby.

•A little power is always consumed even while the unit is in standby mode.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

•When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away. If this happens, set the clock again.

•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away. If this happens, set the clock again.

8