Connecting Speakers, To connect an outdoor AM antenna | JVC UX-H33

English

AM antenna

1

Vinyl-covered wire

(not supplied)

2

AM loop antenna

(supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the power cord.

Connecting Speakers

1	2
Speaker cord
	Speaker cord
Right speaker	Left speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into

the terminal.

Match the polarity between the unit and the speaker terminals: ª to ª and · to ·.

3Release your finger from the clamp.

•DO NOT connect speakers while the power is on.

•DO NOT connect more than one speaker to each speaker teminal.

IMPORTANT: Use only speakers with the same speaker impedance as shown on the speaker terminals on the rear of the unit.

7

Image 10

JVC UX-H33 manual Connecting Speakers, Turn the AM loop antenna until you have the best reception

Contents

UX-H33- Consists of CA-UXH33 and SP-UXH33 UX-H35- Consists of CA-UXH35 and SP-UXH35UX-H30- Consists of CA-UXH30 and SP-UXH30 Page Important for Laser Products Introduction PrecautionsAbout This Manual Contents Top view Location of the ButtonsMain Unit Front view Display window Main unit Remote Control Getting Started Supplied AccessoriesConnecting Antennas To connect an outdoor FM antenna Release your finger from the clamp Connecting SpeakersTurn the AM loop antenna until you have the best reception To connect an outdoor AM antenna To connect the AC power cord Connecting Other EquipmentAdjusting the Voltage Selector To remove the speaker grilles Putting the Batteries into the Remote Control When using the unit in your car Setting the AM Tuner Interval Spacing Setting the ClockCommon Operations Reinforcing the Bass Sound Adjusting the VolumeAdjusting the Tone Bass/Treble Level Presetting Stations Tuning in to a StationListening to FM and AM Broadcasts Press SET Tuning in to a Preset StationTune in to the station you want to preset Press SET again Press 0 Open on the unit When playing a CD-R or CD-RWPlaying Back Discs General notes Basic Disc Operations Programming the Playing Order of the Tracks-Program Play Repeating Tracks-Repeat Play To check the program contentsPlaying at Random-Random Play Press Random Press for cassette deck on the unit Playing Back TapesPlaying Back a Tape Put a cassette in with the exposed part of the tape down Recording on a Tape To record on both sides-Reverse ModeRecording To protect your recording Press ONE Touch Disc Direct RecordingOne Track Recording Repeat steps 2 and 3 to record other tracks you want Set the on-time when you want the unit To turn on Using the TimersUsing Daily Timer and Recording Timer Set the off-time when you want the unit To turn off standby To deactivate the timer temporarily Adjust the clock if you needSelect the volume level With the source to play How the Sleep Timer actually works Using Snooze TimerUsing Sleep Timer Press Sleep Handling cassette tapes MaintenanceCleaning the unit Handling discs Troubleshooting L T a G E S E L E C T O R