Listening to FM and AM Broadcasts
English
Tuning In a Station |
|
|
|
1 When the unit is turned on, | BAND |
press TUNER/BAND to | TUNER |
| |
select tuner mode. |
|
The unit tunes in the last station tuned in (either FM or AM).
2 Press TUNER/BAND to | BAND |
| |
select the band, FM or AM. | TUNER |
| |
Each time you press the button, the |
|
band selection alternates between |
|
FM and AM. |
|
Presetting Stations
You can preset 20 FM and 20 AM stations.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1 Tune in the station you want to preset.
• See “Tuning In a Station” on the left.
2 Press PROGRAM. | PROGRAM |
3 Press and hold 4 or ¢ | SEARCH/TUNING | |
for more than 1 second. |
|
|
|
| |
|
|
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.
If a program is broadcast in stereo, the STEREO indicator lights up.
The PROGRAM indicator and “00” start blinking on the display.
3Press PRESET ∞ or 5 (or PRE DOWN 8/2 or PRE UP 3/8 on the remote control) to specify the desired preset number.
PRESET
DIRECTION PLAY/PAUSE
To stop searching, press 4 or ¢.
notes
When you press 4 or ¢ briefly and repeatedly
4To preset more stations, repeat steps 1 to 3 above, allocating a different preset number to each station.
The frequency changes step by step.
To improve the FM reception |
|
When an FM stereo broadcast is hard to | ST/MONO |
receive or noisy, press REPEAT ST/ | REPEAT |
| |
| |
MONO to switch to the monaural |
|
reception. The STEREO indicator |
|
disappears from the display. |
|
To restore the stereo reception, press REPEAT ST/MONO again so that the STEREO indicator lights up.
To change FM/AM tuning interval
The unit’s default tuning interval is 100 kHz/step for FM reception and 10 kHz/step for AM. You can change this setting to 50 kHz/step for FM and/or 9 kHz/step for AM when using the unit in an area of different frequency allocation system.
1Press TUNER/BAND to select “FM” or “AM”.
2While holding down STOP/CLEAR 7 on the unit, press VOLUME + repeatedly to select the desired tuning interval.
notes
When a new station is stored
The station previously memorized with the same preset number is erased. (The frequency of the new station replaces the previous frequency in memory.)
Tuning In a Preset Station |
|
|
|
1 Press TUNER/BAND to | BAND |
| |
select tuner mode. | TUNER |
|
2Press TUNER/BAND to select the band, FM or AM.
3 Press PRESET ∞ or 5 (or | PRESET | |
| DIRECTION PLAY/PAUSE | |
PRE DOWN 8/2 or PRE |
|
|
|
| |
|
| |
UP 3/8 on the remote |
|
|
control) to select the desired |
|
|
preset number. |
|
|