JVC UX-P450 Setting the Video Output Selector, AV COMPU LINK remote control system, 0PROGRE INTER

English

To connect the AM loop antenna

1Hold

3 Release

2Insert

•If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor reception.

To connect the speaker cords

Connect the right speaker to the RIGHT terminals, and the left speaker to the LEFT terminals.

1Hold

3 Release

2Insert

•When connecting the speaker cords, match the polarity of the speaker terminals: Red cord to (+) and black cord

to (–).

• DO NOT connect more than one speaker to each terminal.

•DO NOT allow the conductor of the speaker cords to be in touch with the metallic parts of the System.

IMPORTANT

The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.

•When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers. Then wait at least 30 minutes before turning on the TV’s main power switch again.

Some TVs may still be affected even though you have followed the above. If this happens, move the speakers away from the TV.

AV COMPU LINK remote control system

This system allows you to use JVC’s TV with simple operations; by starting playing back a disc, the TV automatically turns on and changes the input mode to the appropriate position so that you can view the playback picture.

•To use AV COMPU LINK, you need to connect the System and the TV by using a cord with monaural mini- plugs (not supplied) in addition to the video input/output connection through the COMPONENT jacks, S-VIDEO jack or VIDEO (composite) jack on the rear.

Setting the Video Output Selector

You can select the video output to match it to the color system of your TV.

			NTSC: For an NTSC TV.
VIDEO
			PAL: For a PAL TV.
	OUT
SELECT
			• When using a multi-color system
		PAL	TV, either position will work.
		NTSC

Changing the Scanning Mode	Remote
	ONLY

This System supports progressive scanning.

If you connect a progressive TV through the COMPONENT jacks, you can enjoy a high quality picture from the built-in DVD player by selecting “PROGRE.”

PROGRESSIVE

0 PROGRE

INTER

(at the same time)

PROGRE Progressive scanning. For a progressive TV.

INTER Interlaced scanning. For a conventional TV.

6