or
DISPLAY /CHARA
TRACK
MARKING
TRACK
MARKING
SET
•Normally the input level should be adjusted so that the segments for 0 dB blink at the peak level.
•When the input level is too high, the OVER indicator will light up, resulting in distorted recording.
To display the remaining recording time ——————
In Rec/Pause or during recording, press DISPLAY/CHARACTER on the main unit or the remote control unit.
Each press of the button switches the elapsed recording time display and remaining recording time display alternately.
remaining recording time
Track marking ———————————————————
The track numbers on the MD are marked at the beginning of each track. The track numbers are identified by these “track markings” and each section between two track markings are considered as a track.
For analog input:
You can create the track marking automatically or manually.
Automatic track marking:
Press TRACK MARKING on the remote control unit to select “AUTO”.
•A track marking is automatically recorded every time a blank of more than 3 seconds is detected.
Manual track marking:
1 Press TRACK MARKING on the remote control unit to select “MANUAL”.
2When the point you want to record a track marking comes during recording, press SET on the remote control unit.
This operation records a track marking at the point where the button is pressed.
For digital input:
When tracks are recorded from a CD player by digital input, track markings are recorded automatically at the points where the CD tracks change.
16
