JVC XM-228BK manual Erasing all tracks in an MD ALL ERASE, Using the numeric keys, To exit editing

SET

ENTER

or

or

TITLE /EDIT

or

Using the numeric keys:

Select the track number with the numeric keys on the remote control unit. The selected track is repeatedly played.

Then press SET on the remote control unit.

To select a track, see “Selecting a track with the numeric keys” on page 9.

•If you selected a wrong track number, press 7STOP/CANCEL on the main unit or CANCEL on the remote control unit and select the correct track number.

•If the display shows “TRACK PROTECTED”, the selected track has been protected against accidental erasure by other component than the MD recorder in use. If you still want to erase the track, go to step 4. If you will not erase it, press EDIT on the main unit or the TITLE/EDIT on the remote control unit.

4 Press ENTER on the main unit or the remote control unit.

The change made above is entered	1 2 3 4 5
temporarily in the memory. The
display shows “EDITING” and the	Decrements by 1
TOC indicator lights up.

5Press 0 on the main unit or the remote control unit to eject the MD.

The data in the memory is written in the MD before it is ejected. The display shows “UTOCwriting” during MD writing operation.

•Be careful not to apply impact to the MD recorder during writing data in the memory in the MD. Otherwise the recording may be unplayable later.

•The data in the memory is written in the MD also when the unit is switched to Standby mode while “EDITING” is being displayed.

To exit editing:

Press EDIT on the main unit or the TITLE/EDIT on the remote control unit before pressing ENTER in step 4. Then, press the same button repeatedly until the editing track number is displayed.

Caution

•Once erased, the track can never be restored. An MD containing recording that you do not want to erase should be protected by sliding the protect tab (see page 36).

Erasing all tracks in an MD (ALL ERASE)

The data recorded in an MD can be erased entirely to turn the MD into a blank disc.

1Press EDIT on the main unit or the TITLE/EDIT on the remote control unit to select “ALL ERASE”.

The ALL ERASE indicator lights up.

Each press of the button switches the editing functions as follows.

•When TITLE/EDIT on the remote control unit is used, the disc title is displayed after “ALL ERASE”.

DIVIDE JOIN MOVE ERASE ALL ERASE

MD total playing time display (Disc title)

Blinks

1 2 3 4 5

6

24