JVC UX-G6R Connecting Speakers, To connect an external AM antenna, Open the speaker terminal

Continued

AM antenna

ANTENNA	Vinyl-covered wire
	(not supplied)
	AM
	LOOP
AM
EXT
FM 75
COAXIAL
AM loop antenna (supplied)

Connecting Speakers

You can connect the speakers using the speaker cords.

1	2, 3
		Red
Speaker Cord		Speaker Cord
RIGHT	LEFT	SPEAKERS
Black
Right speaker		Left speaker

1 Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2 Turn the AM loop antenna until you have the best reception.

To connect an external AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

• Make sure the antenna conductors do not touch any other terminals and connecting cables.

•Keep the antennas away from metallic parts of the units, connecting cables, and the AC power cord.

1 Open the speaker terminal.

2 Insert the end of the speaker cord to the terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

3 Close the speaker terminal on the rear of the unit.

When connecting speaker cords

• Make sure to connect the cords correctly following the right series of above steps.

During operation, wrong connection or a short circuit make the power turned off to protect the system.

The clock loses the setting and is reset to “0:00”. Also the MD recording may fail.

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

8