Troubleshooting
If you are having a problem with your system, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the units has been physically damaged, call a qualified person, such as your dealer, for service.
Symptom
No sound is heard.
Poor radio reception.
Possible Cause
•Connections are incorrect, or loose.
•Headphones are connected.
•Volume level is set to “–
•The antenna is not connected correctly.
Action
•Check all connections and make corrections (see pages 6 – 9).
•Disconnect the headphones (see page 12).
•Adjust the volume again (see page 11).
•Reconnect the antenna securely.
• The AM loop antenna is too close • | Change the position and direction |
to the units. | of the AM loop antenna. |
Unable to record onto a tape.
The CD skips.
Unable to operate using the remote control.
•The FM antenna is not properly extended and positioned.
•The AM radio noise interferes with tape recording.
•You are using a tape without a protect tab.
•
•The CD is dirty or scratched.
•The path between the remote control and the remote sensor on the front panel is blocked.
•Extend FM antenna to the best reception position (see page 7).
•Set the BEAT CUT selector again (see page 27).
•Cover the hole with adhesive tape (see page 34).
•Remove the foreign matters.
•Clean or replace the CD (see page 33).
•Remove the obstruction.
Loaded CD and tape cannot be ejected.
The CD does not play.
Operations are disabled.
• The batteries have lost their |
| • Replace the batteries (see page 6). |
charge. |
|
|
|
|
|
• The main AC power cord is not |
| • Plug in the AC power plug. |
plugged in. |
|
|
• The system is under the recording |
| • Stop the recording if required (see |
operations. |
| pages 27). |
|
|
|
• The CD is upside down. |
| • Put in the CD with the label side |
|
| up. |
|
|
|
• The |
| • Unplug the system then plug it |
malfunctioned due to external |
| back in. |
electrical interference. |
|
|
35