JVC AX-UXG6 Presetting Stations, To preset stations manually - Manual Preset, Press SET button

Models: TD-UXG6 AX-UXG6 SP-UXG6 UX-G6R XT-UXG6R

1 40
Download 40 pages 46.77 Kb
Page 18
Image 18
Presetting Stations

To preset stations manually — Manual Preset Continued

Presetting Stations

You can preset up to 30 FM and 15 AM (MW/LW) stations into memory by following two methods: manual/automatic presettings.

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

To preset stations manually — Manual Preset

1 Press 4/ ¢(lower/higher frequencies) button to tune in the desired station manually.

2 Press SET button.

“SET” appears in the display window for a while (not blinking).

Note that “SET” message disappears, presetting procedure is cancelled.

3 Rotate MULTI JOG dial or press repeatedly UP/ DOWN button to select the preset channel numbered from 1 to 30 on FM, or 1 to 15 on AM.

Note that the selected channel “02” disappears, presetting procedure is cancelled.

4 Press SET button again.

“STORED” appears in the display window for a while.

5 The tuned station in step 1 is now stored in the preset channel selected in step 3.

Storing a new station on an used channel erases the previously stored one.

To preset stations automatically — Auto Preset

You can automatically preset 30 FM, 15 AM (MW/LW) stations. Preset numbers will be allocated as stations are found, starting from the lowest frequency and moving up to the higher frequency.

On the remote control only:

1 Press FM/AM button to select a desired band.

2 Press and hold AUTO PRESET button on the remote control for more than two seconds.

The system automatically starts searching for stations with the strong signals continuously, and they are stored successively into memory as follows:

Ç

Ç

Ç

When you unplug the AC power cord or if a power failure occurs

The preset stations will be erased in a few days.

If this happens, preset the stations again.

To change the FM reception mode

When an FM stereo broadcast is hard to receive or noisy, press FM MODE button on the remote control so that MONO indicator lights in the display window. Reception improves.

To restore the stereo effect, press FM MODE button again so that STEREO indicator lights in the display window.

In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo.

15

Page 18
Image 18
JVC AX-UXG6, XT-UXG6R Presetting Stations, To preset stations manually - Manual Preset, To change the FM reception mode