JVC LVT0865-004A, XV-THV70R, SP-XCV70 manual DVD Playback

PROBLEM	POSSIBLE CAUSE	SOLUTION
Sound from one front speaker only.	The speaker cord is not connected	Connect the cord correctly.
	correctly.	(See page 13.)
	Left-right balance is not set properly.	Adjust the balance properly.
		(See pages 63 and 70.)
No sound from the center and/or rear	The speaker setting is incorrect.	Set the speaker setting properly.
speakers.		(See pages 64 and 70.)
The system does not work correctly.	Lightning or electronic noise interferes	Switch the power off, and remove
	with operation of the microcomputer.	and re-insert the power plug in the
		socket.
	Immediately after beginning to heat the	Switch the power off and leave the
	room, the system was moved to a cold	unit a few hours before switching
	location causing condensation to form	the power on again.
	inside.

General

No picture is displayed on the TV	The video cord or SCART cable is not	Connect the cord correctly.
screen.	connected correctly.	(See page 10.)
	The RGB-Y/C selector is not set correctly. Set it proper for the connection and
		your TV. (See page 10.)
	TV input selection is incorrect.	Select the correct input on the TV.
	The disc is not playable.	Use a playable disc. (See page 6.)
A disc cannot be played.	The system’s and disc’s Region Code	Replace the disc. (See page 6.)
	numbers are incompatible.
	Parental Lock is in use.	Enter password to change the
		parental level. (See page 68.)
A disc cannot be played and “0:00” is	The disc is inserted with its label and	Insert the disc correctly.
displayed on the display window.	data sides inverted.	(See page 28.)
	The unplayable disc is inserted.	Replace the disc. (See page 6.)
Video and audio are distorted.	The disc is scratched or dirty.	Replace or clean the disc.
		(See page 72.)
	A VCR is connected between the center	Connect the center unit and TV
	unit and the TV.	directly.
	With some discs, a picture may be	Set “PROGRESSIVE MODE” to
	blurred when setting “PROGRESSIVE	“VIDEO.” (See page 62.)
	MODE” to “FILM” or “AUTO.”
The picture does not fit the TV screen.	“MONITOR TYPE” is not set correctly.	Set the monitor type correctly.
		(See page 62.)
	The TV is not set correctly.	Set the TV correctly.
No subtitle appears on the TV screen		Some DVDs are programmed to
though you have selected as your		always display no subtitle initially. If
initial subtitle language.		this happens, press SUBTITLE on
		the remote control after starting
		play. (See page 45.)
Audio language is different from the		Some DVDs are programmed to
one you have selected as your initial		always use the original language
audio language.		initially. If this happens, press

AUDIO on the remote control after starting play. (See page 46.)

DVD Playback

74