Kane Industries C6713CPU 7 Environment

ARDWARE

EFERENCE

UIDE

MICRO

LINE

C6713CPU

Date : 28 November 2005

Doc. no. : C6713CPU_HRG

Iss./Rev : 1.1

Page : 44

7 Environment

7.1 Minimum Connections

This chapter shows how to set up the C6713CPU for use without a micro-line® Power Supply

carrier board. Please refer to chapter 7.4 for the supply voltage limits.

3.3 V

Voltage

Regulator

Figure 8: Supplying the C6713CPU with power

CAUTION:

The C6713CPU is not protected against reversed voltage. Please be careful when connecting

power supply to the board. Applying reversed voltage will damage the board.

CAUTION:

The power up voltage ramp time must be at least 0.6 ms. The ramp time is measured from 10% to

90% of the full nominal voltage swing. Direct plugging a 3.3V power cable into a working 3.3V

power supply may damage the board.

Contents

Main Hardware Reference Guide micro-line C6713CPU High performance DSP / FPGA board Page Page Page Page C6713CPU 1 Preface 1.1 Document Organization 1.2 Documentation Overview 1.3 Notational conventions C6713CPU 1.4 Trademarks Page 2 Hardware Overview Page Page 2.2 Connectors 2.3 Interfaces and Hardware Components C6713CPU Page 2.4 Status LED's 2.5 DSP peripherals Page Page Page 3 Memory Maps and Description of the PLD Registers 3.1 TMS320C6713 Memory Map 3.2 C6713CPU Address Map 3.3 Internal fast SRAM 3.4 DSP Peripherals 3.5 External SDRAM 3.7 Endianness 3.8 EMIF Configuration 3.9 Description of the PLD Board Registers 3.10 Description of the PLD Registers Page Page Page Page 4 Boot Process and Default Setup of the C6713CPU 5 Using the Flash File System 6 Description of the micro-line Board Connectors Table 11: Pinout of the micro-line connectors 6.3 Pinout Tables of the micro-line Page Page 6.4 Pinout of the JTAG Connector FPGA J TAG connec tor DSP JTAG connecto r (fits TI emulator POD) top view 6.5 Function of the micro-line Connector Pins Page Page Page Page Page Page Page 7 Environment 7.1 Minimum Connections Date : 28 November 2005 Doc. no. : C6713CPU_HRG Iss./Rev : 1.1 Page : 45 D standard PC RS-232 connector Sub-D 9pin socket; fits directly into a PC front view Figure 9: Connecting the serial interface (RS-232) to a PC 7.2 Changing the Board Configuration Page 7.3 Signal Levels and Loads 7.4 Supply Voltage 7.5 Power Consumption 7.6 Reset Timing 7.7 Ambient Temperature 7.9 Dimensions of the Board Date : 28 November 2005 Doc. no. : C6713CPU_HRG Iss./Rev : 1.1 Page : 51 Figure 13: Complete micro-line footprint 7.10 Spare micro-line Connectors 8 List of abbreviations used in this document 9 Literature references