Safety instructions - important notes

If the fuse responds, the source of the fault must be eliminated. The defective fuse should only ever be replaced with a fuse of the same rated value.

Never remove or bridge the fuse in the cable or in the receiver (UFD 170)! Cable fire hazard!

3.Connecting the power supply cable lead marked “Ignition” activates the turntable function for automatic lowering of the antenna. This lowering takes place as soon as the vehicle ignition circuit is turned on. When connecting the control unit to the on-board network, it must be ensured that the “+12V”, “Earth” and “Ignition” wires cannot be broken by switches connected in series, as this can deactivate the automatic lowering function.

Exceeding the normal vehicle height by not lowering the antenna increases the risk of accidents! The driver is responsible for the condition of the superstructure and external fittings!

4.While downloading software for the UFD 170 satellite combi receiver, the caravan ignition may not under any circumstances be turned on as this can result in impairment, faults or loss of function.

Never turn off the receiver (UFD 170) during the update process, as otherwise you could lose the entire software. You would then need to re-install it at a service centre or using a PC and null modem cable.

5.Note on satellite search: If the vehicle is not on supports during the satellite search process and people are moving around inside it, there is a danger that the oscillations of the vehicle will mean that the satellite cannot be found. It should also be ensured that the vehicle is not oscillating when software download via satellite, as otherwise the download may fail.

6.For installation, the turntable HDP 171 may be used in conjunction with the UFD 170 in manual mode (see “installation and connection”, “installation of the BAS 60 planar antenna” sections).

After installation of the BAS 60 planar antenna, the HDP 171 must be put in the park position with the reset command. The reset command can be accessed via the receiver menu (menu element “HDP antenna set-up”). Only then is the HDP 171 released by the software for automatic searching. This concludes the installation of the HDP 171.

The instructions in the installation and operating manuals for these devices and for the extensions and superstructures must absolutely be heeded!

11

Page 11
Image 11
Kathrein MobiSet 3 CAP 310, MobiSet 2 CAP 210 manual Safety instructions important notes