Installation and connection

 

To ensure secure adhesion, the height difference of the roof curve

 

 

may not be more than 1 cm over a length of 2 m, as otherwise the

 

 

gap between the roof and the mounting plate would be too big to be

 

 

filled by the sealing glue.

 

As the vehicle is constantly subjected to vibration loads during

 

 

travel, the roof below the antenna unit is also subject to significant

 

 

loads. Please note given the nature and capacity of your vehicle roof

 

 

(see also operating manual for the vehicle) that the weight of the

 

 

antenna unit is approx. 14.5 kg. In case of doubt, consult a qualified

 

 

dealer or your vehicle’s manufacturer.

 

The roof duct provides a waterproof channel to feed the three

 

 

connecting cables (antenna, control unit and power supply cables)

 

 

into the interior of the vehicle directly underneath the turntable. If you

 

 

prefer a different method of laying the cables, they can be run out

 

 

of the rear of the turntable via the channel provided in the mounting

 

 

plate. The cables must then be run along the roof of the vehicle in a

 

 

protected cable duct (not supplied).

Note:

The cables may not be cut, as otherwise the proper functioning of

 

the unit can no longer be guaranteed.

13

Page 13
Image 13
Kathrein MobiSet 3 CAP 310, MobiSet 2 CAP 210 manual Cables may not be cut, as otherwise the proper functioning