COMMON INTERFACE
You can find out which Conditional Access modules are in the CI slots on the UFS 740sw and which Smartcard is in which CA module from the “Mainmenu” under “Settings”, and the “Common Interface” menu.
Confirmation is by pressing the button.
Use the buttons to select one of the two slots in which the CA module is located (“Module inserted”) and then press the button. You will then see the menu generated by the CA module.
The screenshots below depend on the specific module and card, and so are only intended as examples:
From this menu, your card and your PIN code allow you to access various channels from your
“CryptoWorks” has been selected as an example here. The details can be different for each CA module. Always follow the instructions supplied by your
Note: The module displays may be shown in English, even if you have selected German as the menu language, because the menu is generated directly by the module!
Information for Conax, SECA, Viaccess and CryptoWorks users:
Note that with monthly activation intervals, the channel providers have different procedures for activating Pay TV cards. Activation may therefore be a few days before or after the beginning of a new month. During this activation period, the CA module and card must be in the slot, and the receiver must be turned on a set to the booked Pay TV channel. Follow the instructions from the Pay TV provider.
If your Pay TV card is then still not enabled, we recommend you briefly withdraw the CA module with the card out of the slot, with the receiver switched on, and then
This information has nothing to do with the properties of the unit; it is merely intended to assist you.
The various items can be selected using the buttons and called up using the button. Press the button to exit the menu again.
51
