|
| Assembly |
|
| ||
12 | Front Axle | Front Wheel | 14 | Right Grip | Left Grip | |
Bushing | (Flat Side | |||||
| (Ring End | First) |
| Large Hole | Small Hole | |
| First) |
|
|
|
| |
| Washer |
|
|
|
| |
|
| Hubcap |
|
|
| |
|
| (Indented |
|
|
| |
|
| Side Out) |
|
|
| |
|
|
| • Turn the vehicle upright. |
| ||
• Slide a washer onto a front axle. |
| Note: The left and right grips are not interchangeable! | ||||
| The hole in the left grip is smaller than the hole in | |||||
• Slide a bushing, ring end first, onto the front axle. | ||||||
the right grip. |
|
| ||||
• Slide a front wheel, flat side first, onto the front axle. | • Fit the left grip on the end of the left handlebar. | |||||
• Slide a hubcap, indented side out, onto the front axle. | • Fit the right grip on the end of the right handlebar. | |||||
|
|
|
| Hint: If it is difficult to slide the grip onto the handlebar, | ||
|
|
|
| moisten the inside of the grip with water. | ||
|
| Cap Nut | ||||
| 13 |
|
|
| ||
| Cap Nut |
|
|
| ||
|
|
|
|
| ||
|
| Assembly |
| 15 |
| |
|
| Tool |
|
| ||
Seat
1
2
| .437" |
|
| |
|
|
| • Fit the tab at the front of the seat into the slot in the | |
|
|
| vehicle near the handlebars. | |
• Fit a cap nut on the end of the front axle. | ||||
• “Snap” the tab at the back of the seat into the slot near | ||||
• Fit the cap nut assembly tool over the cap nut. Tap the | ||||
the rear of the vehicle. | ||||
end of the cap nut assembly tool with a hammer to |
| |||
secure the cap nut on the end of the axle. Pull on the |
| |||
front wheel to be sure it is secure. |
| |||
•Repeat steps 11 and 12 to assemble a washer, bushing, front wheel, hubcap and cap nut to the other front axle.
10
